| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
01-10-2003, 11:59 AM
|
||||
|
||||
I have one dash light, That will not come on.
The wiring system is the plastic clips with wires that go to the bulbs. Are these clip sets made any more ? Can you wire them direct ? Rusty 67GTO 
__________________
........I'm just learning as I go....... |
|
#2
01-10-2003, 11:59 AM
|
||||
|
||||
|
I have one dash light, That will not come on.
The wiring system is the plastic clips with wires that go to the bulbs. Are these clip sets made any more ? Can you wire them direct ? Rusty 67GTO
__________________
........I'm just learning as I go....... |
|
#3
01-10-2003, 01:33 PM
|
||||
|
||||
|
If you mean the twist in plugs that hold a 194 bulb yes they can be purchased. Thats what my 70 uses, not sure if thats what is in a 67 though?
Oops, guess not. I looked up a 67 gauge set on ebay to see one. Looks different. Looks like the snap in plugs like are in a clock or tach in a 70. I would go to an auto store and see what they have in the electrical section. theres quite a few different bulb plugs there usually.  GR-RRR! [This message was edited by 428GTO70 on January 10, 2003 at 03:42 PM.]
__________________
 1970 GTO 458 CID .040 over 4 Bolt 428 Block, Forged Eagle 455 Crank, 295 CFM SD KRE D-Ports, SD Old Faithful HR Cam + Comp HR Lifters, PPR Maxx-lite rods, Racetec pistons, PRW 1.65 SS Rockers, 900CFM Holley HP TBI, Performer RPM, Hooker Super Comps, 3" X-Pipe into 2.5" mufflers/tailpipes, 2.75 1st TH400, Continental 13" Converter, 8.5" 3.08 Posi. Everything installed, fired up and tuning has begun! |
|
#4
01-11-2003, 08:38 AM
|
||||
|
||||
|
Actuall the plastic clips clip on to each other in a sussesion. eacc clip the has a wire that goes to each bulb. I suppose GM's thinking was that you could keep adding on.
Problem is the circuit stops half way. I have tried re arranging them, No help. I am almost ready to start spicing. My luck it will make it worse. Rusty 67 GTO
__________________
........I'm just learning as I go....... |
|
#5
01-22-2003, 02:48 PM
|
|||
|
|||
|
I just finished putting new lights in my dash and I hated those plastic bulb holders that unsnap and swing down. they have a hot wire that connects all across the dash. is that what you have? I kept burning wires until I found one twist-on holder that had no bulb and was grounding itself. I also had a turn signal light that was not working. It was a mess but all was well once I found that one bulb holder that was grounding. I hope this is of some help.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
