[Gary H]

Who offers control arm bushings and ball joints for a 60"? How about tie rod ends and a center link?

[Poncho60]

If you are seriously looking/interested I have some of the parts you're looking for.

Moog upper ball joints
Front a-arm shafts
Outer tie rod ends
Front lower shafts & bushings
Rear axle complete set of bushings

I'd have to check to see what else I may have forgotten. Some of these parts are off brand to me at least, but I've had them so long pretty sure it's not Chinese junk.

Regards Randy A.

[Gary H]

PM sent

[ScotM]

I got the upper front shaft bushings and rubber seals from CPR. I recall Ames also listed them in catalogue. Outer tie rods are readily available in after market and also NOS show up on ebay. The inner tie rods are a different story...just not available, as no one makes them for the 1960. I have only seen the inners on ebay once and they were for a HD-police/taxi so larger diameter. As for the center link, its a bit of a different animal and have only seen this reproduced from Rare Parts Inc. It pretty pricey, but here is the link if interested.

https://fcrcmachine.com/products/rar...-ventura-27104

If your's is not bent or damaged it can be rebuilt, as the inside fittings can all be replaced. I do see those kits fairly frequently on ebay as well.

Hope this helps

[Poncho60]

There's a set of upper a-arm shaft bushings on e-bay right now