| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
01-03-2000, 06:14 PM
|
|||
|
|||
If my block is already at zero deck is there any reason to surface the deck? If there is a need to surface the deck and it is at zero, is the block junk?
Any San Diego recommendations for a competent, quality machine shop in San Diego county? Just like getting second opinions about dovtors I want to get second and third opinions about machine shops.
__________________
Inside of every small problem there is a big one struggling to get out..... |
|
#2
01-03-2000, 06:14 PM
|
|||
|
|||
|
If my block is already at zero deck is there any reason to surface the deck? If there is a need to surface the deck and it is at zero, is the block junk?
Any San Diego recommendations for a competent, quality machine shop in San Diego county? Just like getting second opinions about dovtors I want to get second and third opinions about machine shops.
__________________
Inside of every small problem there is a big one struggling to get out..... |
|
#3
01-03-2000, 11:12 PM
|
|||
|
|||
|
You should be able to cut .002 to .004 and not worry about it. So you have -.004 out the hole. It makes for better quench too.
|
|
#4
01-03-2000, 11:22 PM
|
|||
|
|||
|
[This message has been edited by Todd (edited 07-18-2000).]
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
