[Cammer-6]

need a good pic of the 66-7 hood showing holes for emblem.
I dont have access to any 66-7 hoods right now,but do have a 65 one.
I do know the hole closer to center of hood needs to be welded
but not sure if the lower hole can be reused to put a 66-7 emblem on it.

[6d7gto]

Originally Posted by Cammer-6

need a good pic of the 66-7 hood showing holes for emblem.
I dont have access to any 66-7 hoods right now,but do have a 65 one.
I do know the hole closer to center of hood needs to be welded
but not sure if the lower hole can be reused to put a 66-7 emblem on it.

Measurements from a '67 hood:

Approx. 2 3/8" on center (first hole) from the nose of the hood and approx. 5 9/16" o.c. (second oblong hole) from the nose. If still needed, I will send a photo when my wife gets off the phone!

[ftwmlp]

This is link to an older thread on this subject, hope it helps
https://forums.maxperformanceinc.com...ht=hood+emblem

see pic in post 14

[Cammer-6]

Originally Posted by ftwmlp

This is link to an older thread on this subject, hope it helps
https://forums.maxperformanceinc.com...ht=hood+emblem

see pic in post 14

ok thank you
looks like one hole is common