FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
|
SOLD Parts The parts in here have already been sold. The topics will be kept for a few months for reference. |
|
Thread Tools | Display Modes |
#21
|
||||
|
||||
Torino bearing is 3.150 OD yours should be 2.835?
|
#22
|
||||
|
||||
This might help you guys:
https://www.jalopyjournal.com/forum/...earing.340971/ Tom V. Ford Axle Bearing Housing End is based on Axle Bearing Size (Outer Diameter). Tom V.
__________________
"Engineers do stuff for reasons" Tom Vaught Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward. |
#23
|
||||
|
||||
Looks like you are correct.
Here's where im measuring from. You can press your bearing on this axle as long as the ID is the same ..
__________________
My Half AN Injun..... |
#24
|
||||
|
||||
Thank you Tom....
__________________
My Half AN Injun..... |
#25
|
||||
|
||||
I cannot use them.... quote from Moser "Yes there are big ford bearings for 31 spline axles but no they cannot be used with an axle that was made for small bearing the bearing seats are not the same and location of the bearing on the axle is not the same"
|
#26
|
||||
|
||||
Ok at least we all learned something from this .. Thanks for looking..
__________________
My Half AN Injun..... |
#27
|
||||
|
||||
I originally ordered my 9" housing from Jim Butler with the "Big Ford Bearing Housing ends. I later decided to install the Explorer Rear Disc Brake Kit, It uses a Torino Bearing housing. Axles and Big Ford Bearing axles fit the Torino ends perfectly.
So to me that says that the Small Bearing 31 spline axles are unique to that housing. Learn something new every day. Thanks ponjohn and Charlie. Tom v.
__________________
"Engineers do stuff for reasons" Tom Vaught Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward. |
#28
|
||||
|
||||
I guess there talking about the location (where the bearing sits/ends up after pressing it on) from the bearing to the axle flange is further or closer.. ??
__________________
My Half AN Injun..... |
#29
|
||||
|
||||
Probably because of the housing end offset.
|
#30
|
||||
|
||||
You would think you could put a spacer under the bearing to adjust that. If you had to go the other way you could machine the axle back maybe ? Who knows...
__________________
My Half AN Injun..... |
#31
|
||||
|
||||
bump
__________________
My Half AN Injun..... |
#32
|
||||
|
||||
bump
__________________
My Half AN Injun..... |
#33
|
||||
|
||||
These were hardly used . Very good axles...
__________________
My Half AN Injun..... |
#34
|
|||
|
|||
PM sent
__________________
Monty Frerichs B&M Machine Box Elder SD |
#35
|
||||
|
||||
__________________
"Engineers do stuff for reasons" Tom Vaught Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward. |
#36
|
||||
|
||||
__________________
My Half AN Injun..... |
#37
|
||||
|
||||
__________________
My Half AN Injun..... |
#38
|
||||
|
||||
SOLD
__________________
My Half AN Injun..... |
|
|