[ryan389]

Does anybody have the dimensions where to drill the holes for the rear quarter panel rockers for a 67 GTO?
Also the drill size for the clips.
THANKS

[BOB VIDAN]

You mean the underneath holes?

[ryan389]

No
Isn't there 3-4 molding clips that screw to the outside of the quarter patch panels where they rust out, mine was so rusted out the wasn't any holes to go by.

[BOB VIDAN]

There are little pin head studs that the clip slides over, then the molding snaps on the clip.

[Old Goat 67]

There are four nail heads originally there. See below.

Spacing from front to rear is not that critical, however from the top of the moulding to where they are located is. Best thing I can think of for you to do is put the chrome piece in place and mark the top, so you can figure how much below that they need to be. Then, use some of the screws for windshield moulding to put there to hang the clip onto.

Charles

[ryan389]

Thanks guys!
Who sells the clips?
I don't see them in PY or Ames.
RICH

[BOB VIDAN]

PY has them, RPR24C

[ryan389]

THANKS BOB!!

[hutchwareltd]

Waking up an old post. I can't find the clips at any of the parts houses - Ames, YearOne, OPGI. Anyone know where to get them? I don't like the look of the suggested replacement clip. I think the original PN was G221258.

[Jeff Hamlin]

Ames Cat;

[jhnichols2]

Here are a couple of photos.

[hutchwareltd]

Thanks Jeff, I'll call them. They list them as discontinued online.

Originally Posted by Jeff Hamlin

Ames Cat;

[hutchwareltd]

Thanks jhnichols2 - pics are very helpful.

[jhnichols2]

Restoration Specialties is another source the clips.