| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
03-28-2020, 03:06 PM
|
||||
|
||||
Quarter patch repair
I've got to cut out and replace the lower rear quarter on my 67 bird. I'm thinking I should probably make the weld below the body line. Seems like it would be easier to weld it above but I think it would be less obvious later if the seam was below than above. I've not done this before so I'm learning as I go.
__________________
Robert 69 Firebird-462/Edel round ports/currently running the Holley Sniper/4sp/3.23posi/Deluxe Int/pwr st/vintage air/4wl disc( a work in progress-always ) http://youtu.be/eaWBd3M9MN4 |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
