| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
06-13-2019, 03:28 PM
|
||||
|
||||
RARE "no drill" driveshaft loop doesnt fit
I just ordered one of these and was about 50% confident it would fit. Although it did "bolt in" after barely sneaking by my X pipe, the unit is jammed up tight against the floor boards. The result is a bunch of unwanted vibratory noise from the drivetrain to the floorboards. Guess I'll be taking this off to modify it.
 Anyone else have experience with this part? Wondering if my experience is unique. I'm thinking of yanking it out, heating it up, bending it down, repainting and trying again. Nothing like taking a torch to a NEW part that's supposed to fit.
__________________
************************************* 1968 Lemans. 37,000 original miles. GTO clone. 462ci/KRE 290 heads. UltraDyne 280/288 Solid/850 Qjet by Cliff/Performer RPM/TSP 9.5" in TH400/8.5" 3.42 gears/3950# Race weight/12.58@106 at Bandimere speedway high altitude |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode