| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
03-16-2019, 01:01 AM
|
|||
|
|||
Molding ID Help
Found these moldings getting ready to do a swap meet and don't know what they fit. Ideas? They look to be front fender moldings, are 38" or so long, 1 5/8" on the wide end and do not appear handed.
__________________
Practicing social distancing for 65+ years |
|
#2
03-16-2019, 04:15 AM
|
|||
|
|||
|
Not sure as i cant remember where the ridge is but possibly 50 4dr rear,
think if it was a front spear the door end would be angled |
|
#3
03-16-2019, 09:41 AM
|
|||
|
|||
|
Hummm, it's aluminum not stainless. Did they use aluminum back then?
__________________
Practicing social distancing for 65+ years |
|
#4
03-17-2019, 04:48 AM
|
|||
|
|||
|
Aluminum not stainless, well I'm way off then as pretty sure it would be stainless.
Hopefully someone can jump in with the right/better idea. |
|
#5
03-17-2019, 10:37 AM
|
||||
|
||||
|
I have two 50s, a 2 door and a 4door and there is no trim on either that has the shape of your piece.All the trim on my cars is convex with no sharp ridges.
__________________
Remember no one is perfect. Everyone's butt has a crack in it! |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
