| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#21
11-16-2019, 08:12 AM
|
|||
|
|||
Do not make a bigger hole have it machined as an oval. Could do with a small round stone and dremel tool. Tape up inside cover to make clean up easier.
Sent from my iPhone using Tapatalk |
|
#22
11-17-2019, 10:50 PM
|
||||
|
||||
|
Well I tried one more set. I drilled out all four holes two drill bit sizes bigger than stock. Not only would they not fit on the set screws but I put factory valve covers on and they fit except for hitting the roller rockers. I am sucking it up and buying the Edelbrock. Don’t even try the procomp or trans dapt brand they simply do not fit
__________________
468/TKO600 Ford thru bolt equipped 64 Tempest Custom. Custom Nocturne Blue with black interior. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
