| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
04-30-2015, 01:59 PM
|
|||
|
|||
Help 64 temp wagon
I just bought a 4 door 64 tempest wagon ... Actually very clean very little rust.... My questions are
1 . Will patch panels off a 2 door work ... car has abit of rust at bottom... front and back doors. 2. Where can I buy or what model will fit for rear wheel well lip .....Its not bad just think it`s easier to weld in a patch panel. 3. Drivers side front floor pan has a small soft spot about 2 inches by 2 inches.... is the floor pan from a 2 door the same or close enough. I don`t mind buying the floor pan and cutting it to what I need . I have talked to PY people and they have patch panels for bottom of doors but no one is positive if they are the same as a 4 door. Apparentley they don`t sell wheel well lips ... Other than that car is rust free any help is greatly appreciated .... Last edited by fastgto; 04-30-2015 at 02:02 PM. Reason: mis-spelled a few words |
|
#2
04-30-2015, 03:11 PM
|
|||
|
|||
|
Sorry wrong section
|
|
#3
04-30-2015, 04:52 PM
|
||||
|
||||
|
Your thread belongs right here, the Tempest is not a big Pontiac.
__________________
1964 Tempest Coupe LS3/4L70E/3.42 1964 Le Mans Convertible 421 HO/TH350/2.56 2002 WS6 Convertible LS1/4L60E/3.23 |
|
#4
05-01-2015, 10:02 PM
|
||||
|
||||
|
Door lines are the same so I would guess they would work.Just cut what you need
__________________
64 tempest wagon 421 gasser 
|
|
#5
05-01-2015, 11:37 PM
|
|||
|
|||
|
I sorta figured that but wasn`t 100% sure ....thankyou ...
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
