| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
01-09-2014, 10:01 AM
|
|||
|
|||
455 piston
I was about to rebuild the 455 from our old FE rail to put into my 67 bonny but I had a good look at the bores and I dont think it needs boring. The problem is one of the pistons had the side welded back on and yes we did run low nines with it but I don't trust it in a street engine. Does any one here have a 2nd hand std cast flat top 455 piston. I am more than happy to pay postage to australia. Im not trying to be cheap I just dont want to bore a hard to find 455 block if I can avoid it. Thanks and a happy new year.
|
|
#2
01-09-2014, 12:24 PM
|
||||
|
||||
|
Gavin, I have a complete set you can have just not sure of size. I'm at work but will check when I get home and let you know.
Bill |
|
#3
01-09-2014, 05:34 PM
|
||||
|
||||
|
I have a set of speed pro forged - std very good shape
|
|
#4
01-09-2014, 08:26 PM
|
||||
|
||||
|
I have some extras still on rods if these guys can't help. Oe stuff not aftermarket.
__________________
Illinois Outlaw Gassers 6.27@107 9.97@131 |
|
#5
01-09-2014, 11:08 PM
|
|||
|
|||
|
Thanks guys for your help I will most likley go with a single piston as even with a rod attached it will be easy to mail. Its great to have a site with so many good people.
|
| The Following User Says Thank You to gavin For This Useful Post: | ||
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
