[importsmasher]

bump

[importsmasher]

bump

[436'd skylark]

I would like to see some pictures of the hatch if you still have it. Thanks you can send them via text/picture message at 814-440-4191 if its easier. thanks

[importsmasher]

I don't have the actual hatch (trunk lid) any more; sorry

Thanks,
Importsmasher

[436'd skylark]

how is the trunk floor? Would you be williing to rough cut it out? Thanks

[importsmasher]

It depends on what part(s) of the trunk floor you need. The trunk floor is pretty good; it might have a couple of pinholes in the spare tire area (I would have to go look); however, the right rear frame rail has been cut out, and part of the trunk floor went with it. I can get pictures if you like.

Thanks,
Importsmasher

[436'd skylark]

Some pictures would be great. Thanks.

[importsmasher]

Here are some pictures. It has a little more rust than I remembered. There are two spots, one in the spare tire area and one on the other side right next to where the frame rail was cut out.

Thanks,
Importsmasher

[436'd skylark]

how much would you want for it?

[importsmasher]

That would depend on how much of it you want (which will determine how difficult it will be to cut it out). where would you want it cut?

Thanks,
Importsmasher

[436'd skylark]

I'll take a picture of mine tomorrow and show you what I need. I'm looking for the spare tire well and the tank strap .

[436'd skylark]

I can't seem to get pictures working. I'm looking for the left side with the spare tire well and that gas tank strap support. Basically the entire left side from the middle until as far over as you can get. Thanks

[importsmasher]

Let me take a look this weekend and see how hard it is going to be to remove.

Thanks,
Scott

[importsmasher]

Unfortunately, I just started a "honey-do" remodel project, and I won't be able to get into the garage for a couple of weeks. If you're still interested then, I can take a look.

Thanks,
Importsmasher

[importsmasher]

bump...436'd skylark, are you still needing the trunk floor?

[436'd skylark]

I no longer need the trunk floor, but I am looking for a decent driver door with no rust or body damage. You might have better luck emailing me direct- joemactools@yahoo.com Thanks

[importsmasher]

Originally Posted by 436'd skylark

I no longer need the trunk floor, but I am looking for a decent driver door with no rust or body damage. You might have better luck emailing me direct- joemactools@yahoo.com Thanks

Email sent. Let me know if you don't get it.

Importsmasher

[importsmasher]

bump

[WildBill79]

Did you ever sell the tail panel. If not, what condition is it in, I may be interested

[importsmasher]

I still have the tail panel. It's not perfect, but it is completely rust free. It does have a hole near the license plate where I had a battery cutoff switch. If you are interested, give me an email address and I will get you more pictures.

Thanks,
Importsmasher