[Hesster1977]

Looking for some installation tips. I am ready to begin installation of SE Stripes on my Bandit Trans Am Camaro Conversion. I want it to look as close as possible to the 1977 SE's. So since the Camaro Body is obviously different in almost all areas, my plan is to utilize as much of the Phoenix Graphix's Premolded Stripes, and cut them up and splice together to fit. So I also bought a roll of Straight Striping for connecting the pieces together where neccessary. But the issue is getting striping around curves where the premolded items don't exactly conform to some of the curves & bends.

So my question is -
1. Has anyone installed the Straight Roll Striping around CORNERS/CURVES? It does not seem to like being forced into a curve. So install dry and try stretching it to form the curve?
2. It has been a while since I installed these on my 1977 SE many years ago. Any tips, as there are not instructions other than soapy Water?