| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
06-04-2022, 02:46 AM
|
||||
|
||||
61-62 Temest transaxle pan tube leak
Any tips on sealing up the pan tube? Mine only leaks from this area.
|
|
#2
08-25-2024, 04:01 PM
|
||||
|
||||
|
Where the tube filler meets the pan I mean. It's leaking from there. On my '62 two-speed auto.
|
|
#3
08-26-2024, 08:47 AM
|
||||
|
||||
|
Tube leak
Hey Chris, The dipstick/filler tube is a compression fitting basically like a large brake line. Tightening down the nut should seal it unless there is some sort of damage to the tube or pan. Try to snug it a little tighter. If it still leaks you could remove the tube to check mating surfaces. Greg
|
|
#4
08-26-2024, 11:59 AM
|
||||
|
||||
|
That is very helpful,, thanks Greg. I suppose this should be written in the shop manual but I didn't find it. Will tighten more, and see if that helps. A nut this size can probably take 45-50ft/lbs.
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
