[shuffster]

Ames offers two replacements. Roller and rivet and just the roller that will snap onto the old rivet. The latter would make replacement easy but is this style any good?

Also is there a tool to use in replacing rivets?

Thanks

[MecGen]

Originally Posted by shuffster

Ames offers two replacements. Roller and rivet and just the roller that will snap onto the old rivet. The latter would make replacement easy but is this style any good?



Also is there a tool to use in replacing rivets?



Thanks

Did you find a solution ?

Sent from my SM-T590 using Tapatalk

[shuffster]

I ordered just the rollers from Ames. The original rollers were very brittle and were easy to remove. I installed the replacement rollers using a 4” C clamp to provide the press. Easy.