| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
04-22-2011, 03:21 PM
|
||||
|
||||
E-Head plumbing
Has anyone plumbed E-Heads from both sides to the water crossover and incorporated the heater also?
If so, would they be willing to share pictures and/or secrets to the modification? The nipples that are included with the heads are brass and surely (I'm guessing) not what is used. What's best, hard tubing or flex hoses? |
|
#2
04-22-2011, 10:05 PM
|
||||
|
||||
Plumbing E Heads
This is my set up.
It is installed on a set of stock 7K3 heads. the same set up will work on a set of after market heads using the 3/4 x 3/8 bushing . The part that screws in to the head is called a bushing it is 3/4x3/8 inch npt. This part is an Earl's. Sorry The photo of the cross over does not enlarge. When installed the cross over loops forward and down under the distributor. I don't have a photo of that either.
__________________
Its ok to giggle and snicker, Dont laugh and point Last edited by Ollie; 04-22-2011 at 10:39 PM. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
