[RAIV55]

I just bought a service manual on CD. Long story short it didn't load or work in my computer. I need information on proceedure for turn signal switch replacement.

Thanks!

[goatnut]

On most newer GM vehicles just remove steering column covers to gain access to switch remove usaully 2 or 3 screws and unplug. I will check the manual [on shop pc]tomarrow and get back to you with more accurate details.

[goatnut]

Here it is step #1 disable the SIR system - air bag
2 remove knee bolster
3 loosen steering column bracket nuts
4 remove the steering column trim covers
5 disconnect the steering column bulkhead connector from the vehicle harness
6 disconnect the gray and the black connectors [2] of the switch from the column bulkhead connector
7 disconnect the automatic transmission shift lock control electrical connector
8 remove the wire harness straps from the steering column wire harness [1]
9 disconnect the park position switch electrical connection
10 remove the multifunction switch retaining screws from the switch
11 remove the multifuntion turn signal/hazard switch.

To install reverse procedure.
Hope this helps you.

Rob.

[RAIV55]

Thanks a bunch goatnut! I was dreading the job, but don't sound too bad from your instructions.