[charlie66]

I have a set of Moser axles for a 9" rear for sale . They are 31 spline with bearings ready to bolt one. Very good condition. I up graded to 35 spline .They are 27 1/8 and 31 1/8 5x4 3/4 2.430. these are small ford bearings with built in seals/ o-ring.. 1/2 X 3" long studs.

$250.00 + shipping.

Thank You....

[charlie66]

The axles do have a GM lug bolt pattern....

[charlie66]

bump

[charlie66]

bump

[charlie66]

bump

[charlie66]

bump...

[charlie66]

bump

[charlie66]

bump

[charlie66]

Still for sale

[charlie66]

bump

[charlie66]

Im surprised know one is interested in these.. They were bought new from Moser by me and used for just a season and taken off because I up graded to 35spline . I paid 500.00 for them . There good for 800 hp !

[ponjohn]

What is the width of the housing?

[charlie66]

Originally Posted by ponjohn

What is the width of the housing?

That's a good question , I don't know.

I do know the rear came out of a stock 1969 mustang . So what ever the rear would of measured in one of those.

Ill measure it tomorrow though...

[charlie66]

Looks like its 54.1/4 from the back of each backing plate to backing plate. I measured it under the car so it could possibly be a little different then that number. I did post the axles sizes in my first post though. Those numbers should be all you need as long as you know your current axles size.

[charlie66]

here are some pictures

[ponjohn]

Can different bearings be pressed on for Torino ends?

[charlie66]

Why are they different? What size are they 3 1/2 ? Ill measure the axle so you can compare your bearing ID size to the number I get..

[charlie66]

The axle measures 1.378 where the bearing gets pressed on.. So what ever bearing you have has to be a few thousandths smaller then that. I don't know off hand what the interference size is. If you call Moser or strange they will know...

[charlie66]

What size are your bearings?

[charlie66]

Torino might be the same as mustang no?