FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#61
|
|||
|
|||
I think this is the bearing mod thread asked about in Kinsler's Scat 4.5 crank thread.
|
#62
|
||||
|
||||
Since this thread was brought back up...is this mod done to all the main saddles?
|
#63
|
||||
|
||||
I did it on mine all of them
|
#64
|
|||
|
|||
Has anyone tried machining just the bearings like Go Fast posted ?
|
#65
|
|||
|
|||
Post # 33. Does anyone have contact info, phone number for this person ?
|
#66
|
||||
|
||||
A top bearing shell with a wide but very shallow groove on the backside could be an option on a stock block, rather than cutting a groove in the part of the block that is prone to cracking, may be even better on an aftermarket block too.
I'm looking into these mods for my current stock block turbo combo build, along with a full flow oil filter delete mod too. |
#67
|
||||
|
||||
Hmm, probably the shallow groove on the backside of the shell would weaken it too much over the front groove area..
|
Reply |
|
|