| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
01-05-2020, 12:12 PM
|
|||
|
|||
Upper control arm torque spec
Looking for some help with proper torque setting on the two bolts that attach the pivot shaft (or cross shaft) @ upper portion of the upper control arms. For clarification it's the two bolts @ the outside of upper control arm that run through the rubber bushings & attach to pivot shaft.
The vehicle is a '66 Lemans. Last Summer I replaced all of the front suspension/steering components & yesterday rechecked all nuts/bolts for tightness. I found the above mentioned bolts for upper control (both sides) appeared to be a little more than finger tight. That didn't seem right. Does anyone know what torque setting they should be ? Thanks ! |
|
#2
01-05-2020, 03:22 PM
|
||||
|
||||
|
40(+-)5 LB FT
__________________
When I die, I want to go peacefully like my grandfather did, in his sleep. Not screaming like the passengers in his car. 
Last edited by Jeff Hamlin; 03-25-2020 at 08:11 PM. |
|
#3
01-05-2020, 04:01 PM
|
|||
|
|||
|
Perfect. Thanks Jeff !
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
