 |
|
| SOLD Parts The parts in here have already been sold. The topics will be kept for a few months for reference. |
|
|
Thread Tools | Display Modes |
|
#1
02-15-2020, 01:48 PM
|
|||
|
|||
Comp Cams #995 Valve Springs
used Comp Cams #995 Valve Springs, for Pontiac D-port heads (checked OK at 95 lbs. @ 1.70" installed height), dual springs with outer, inner & dampner, set of 16 $25 plus shipping
|
|
#2
02-16-2020, 12:50 AM
|
|||
|
|||
|
Did you have to do any work on the heads to fit these springs?
|
|
#3
02-16-2020, 02:32 PM
|
|||
|
|||
|
[QUOTE=CatalinaMike;6111061]Did you have to do any work on the heads to fit these springs?[/QUOTE
No work needed...they are the same diameter and height as stock valve springs. They were installed on '68 400 #62 heads with no problems. |
|
#5
02-19-2020, 02:32 PM
|
||||
|
||||
|
I believe I’ll take these. I’ll PM you.
|
|
#6
02-19-2020, 08:49 PM
|
|||
|
|||
|
Just FYI, stock install height is a little less then 1.6...
Comp has a tool to cut the seat if you want to go that route. I used these on my 6x-8, but installed the earlier valves making install height closer to 1.7. Sent from my iPhone using Tapatalk
__________________
1979 Firebird Trans Am 301/4spd (Now 428) 1977 Firebird Formula 400/Auto 2007 Grand Prix GXP 5.3L |
|
#8
02-20-2020, 03:44 PM
|
|||
|
|||
|
Sale pending to...........?
|
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
