FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
Covid-19 Virus Oil Filter Cutter
I used my virus holiday to build a homemade oil filter cutter. Works like a charm, threw it together with spare hardware lying around. Stole an old cutter wheel from a rust old tubing cutter. 15 minutes on the milling machine, about the same on the drill press, some thread tapping, couple of spot welds and I have a super heavy duty filter cutter.
|
The Following 2 Users Say Thank You to dataway For This Useful Post: | ||
#2
|
||||
|
||||
Nice job!
|
#3
|
||||
|
||||
__________________
"No replacement for displacement!" GTOAA--https://www.gtoaa.org/ |
#4
|
||||
|
||||
yup thats nice.
__________________
1969 carousel red firebird 455, richmond 5 speed 1964 540 gto 1971 lemans sport convertible 1972 Maverick under slow construction |
#5
|
||||
|
||||
Very nice
|
#6
|
||||
|
||||
Maybe I can build one, if the scare gets to Oklahoma.........
__________________
1977 Black Trans Am 180 HP Auto, essentially base model T/A. I'm the original owner, purchased May 7, 1977. Shut it off Shut it off Buddy, I just shut your Prius down... |
#7
|
||||
|
||||
Some nice fabrication going on there for minimal $ and should be good for a lot of filter inspections.
Tom V.
__________________
"Engineers do stuff for reasons" Tom Vaught Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward. |
#8
|
|||
|
|||
Very nice and thanks for sharing.
|
#9
|
||||
|
||||
Address to send filters. Lol
__________________
🧩 Burds Parts, Finding those Hard to Find PCs, no Fisher Price Toys Here Just Say No To 8” Flakes F ire B irds 🇮🇱 |
#10
|
||||
|
||||
Nice!! That thing will last forever!!
__________________
" Is wearing a helmet illegal" Mike Kerr 1-29-09 |
#11
|
||||
|
||||
Very creative! Nicely done!
|
#12
|
||||
|
||||
Blockbuster Video
1000 Colonial Farm Road McLean, VA 22101 |
#13
|
||||
|
||||
Hehehe... the only stock I had wide enough was 1/4" plate .. so yes it's pretty sturdy. Ordered a new cutter wheel for it today, something made for steel rather than the copper cutter installed now.
Like a lot of my homemade stuff I'll probably never paint it, but in this case it might not get rusty cause it will get plenty of oiling. |
Reply |
|
|