[Tom McQueen]

I finally found a glove compartment door Judge emblem. I know there is a drawing (and I have a copy) of the correct location for mounting a Judge wing on the decklid. Is there a similar drawing showing the correct emblem location on the glove compartment door?

[Tom McQueen]

I finally found a glove compartment door Judge emblem. I know there is a drawing (and I have a copy) of the correct location for mounting a Judge wing on the decklid. Is there a similar drawing showing the correct emblem location on the glove compartment door?

[Darrell]

I could use that location also. I have seen a blueprint on this but it was for holes for the original emblems. I have a sticky back.

[judgeragtop]

If you want, I have two original doors with the original emblems. The doors are off the dash so I could easily take a picture of one with a ruler beside it for reference?

Mike

1970 GTO Judge RAIV 4 speed
1970 GTO Judge Convt RAIII 4 speed

[Tom McQueen]

JudgeRagtop....I would really appreciate that. You can post the pics or feel free to E-mail them to me. Thanks again.

[Held for Ransom]

From the center of the H (at the edge of emblem) in THE to the top of glovebox door is 4"*. From the end of the E (at the edge of emblem) in JUDGE to the outer edge of glovebox door is 2"*.
* tolerance is -0"/+1/16".

[Tom McQueen]

Very helpful. Thank you.

[judgeragtop]

I measured my original last night and that blueprint above is right on. Close enough anyway.