| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
01-04-2009, 01:37 PM
|
|||
|
|||
1964 Lemans Hardtop Beltine Molding
Looking for help on how to remove and replace the beltine/door ledge moldings on my 64 Lemans hardtop. I have found a couple of places to recondition the molding, however I have no clue how to remove and replace the molding. If anyone has any experience on how to do this, I would appreciate the information.
Thanks Will |
|
#2
01-04-2009, 01:58 PM
|
||||
|
||||
|
im not sure but would think their the same as 66/67
inside the felt strip there are small phillips screws that hold it on hope this helps
__________________
aaaargh |
|
#3
01-10-2009, 06:55 PM
|
|||
|
|||
|
On most cars there is also a screw at the very front. The vent window needs to be removed, or at the very lease raised up a little to access that screw. Body by Fisher manual is very helpfull.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
