 |
|
| Non Pontiac Motors in Pontiacs includes factory 403,305,350 Chevy, Buick V6, Also Pontiac Motors in non-Pontiacs! |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
10-04-2010, 11:24 AM
|
|||
|
|||
Chevy Heads???
I have a friend willing to let go of the below captioned set of heads. Question: will these these heads swap with the #18 heads I currently have and still have all of the bolt holes for A/C, Power Steering, Alternator, etc. Know its not going to be an entirely pontiac motor when done but it could save a lot of $ if it will work. Plan on installing on a 350 bored .030 over with standard stroke and new rods & pistons, etc.
pre 86 chevy bowtie heads. angle plug, 64cc chambers, 2.02 int, 1.60 exh manley stainless valves. 1.50 double valve springs, 1.5/1.6 mixed ratio crane high energy roller rockers with stud girdles (gold anodized) heads fresh out of machine shop never installed. the rockers are the only thing that have been used. call me or email if you have any other questions. |
|
#2
10-04-2010, 12:40 PM
|
||||
|
||||
|
Sorry, small-block Chevy heads won't even come close to bolting onto a Pontiac block of any kind.
|
|
#3
10-07-2010, 06:23 PM
|
|||
|
|||
|
no dago, you really did not ask if you could bolt chevy heads on a pontiac block..really?
|
|
#4
10-09-2010, 06:18 PM
|
|||
|
|||
|
Unfortunately yes
$$$$$ I was offered fully machined port & polished never been used since heads with roller rockers new valves etc. for free. I know this is an ultimate sin, however I was willing to make it for a $2500 set of free heads. I apologize to everyone on the site that I offended.
|
|
#5
10-09-2010, 06:39 PM
|
||||
|
||||
|
Take the free Chevy heads and sell them.
Use the proceeds to have the #18 heads worked on, they're actually fairly rare 1968 350 HO heads that would be perfect for any performance 350 build up. |
|
#6
10-09-2010, 07:15 PM
|
|||
|
|||
|
you didnt offend us..the chevy heads wont fit..
|
|
#7
10-11-2010, 09:17 AM
|
|||
|
|||
|
Value
Just bumping the info with a new question. If I get these heads does anyone have an Idea of what the pair as described would be worth.
pre 86 chevy bowtie heads. angle plug, 64cc chambers, 2.02 int, 1.60 exh manley stainless valves. 1.50 double valve springs, 1.5/1.6 mixed ratio crane high energy roller rockers with stud girdles (gold anodized) heads fresh out of machine shop never installed. the rockers are the only thing that have been used. call me or email if you have any other questions.Casting # is 14011048. Should come with ARP pushrods and the lifters. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
