[midway64]

looking for a good set of e-heads 72cc around 330 cfm

[Apache Warrior]

Are you looking to run ethanol?

I have a set of 340CFM round-port original bathtub style Edelbrock heads that I am about to post for sale on May 1st.

They were purchased from SD Performance back in 2006 as 72cc (part# 60509) semi-finished heads that Dave completed as his 305CFM head package. SD Performance converted the bathtub style chamber to their heart-shape chamber also. I then had them max ported by Calvin Hill (Hill Performance) to 340CFM along with adding stainless steel tubing to support each head bolt/stud access boss and I had 9/16 stainless steel tubing inserted and epoxied into the pushrod holes. You can run up to a 1/2" pushrod with good clearance still, if needed. The epoxy used was Loctite gray and it turned out well. Epoxy would not be an option for a potential buyer if they choose to run ethanol as I have been told that it (epoxy) will degrade over time.

I cc'd these heads twice since the final valve-job and heart shape chamber mods were done and they cc'd right at 78cc's.

The Edelbrock logo has been ground off the exhaust center-ports.

I have some pictures I will post up soon and I have molds made for a single exhaust and intake port that I will share also.

Included are new (never run) Ferrea stainless steel, one-piece forged 6000 series valves, 2.19 intake and 2.11 exhaust, cut on a new Serdi valve cutting machine with a 5-angle valve job. They both measure the same height (5.344). The valve seats have been cut .050 for additional spring height adjustments, if needed. I also had the spring seat circumference opened up to 1.780 to run a nice valve spring cup. You can place an inside spring locator on top of the cup nicely to adjust spring height if needed.

I have the original Edelbrock cylinder head boxes for shipping.

These do not include valve springs, inside locators, retainers, locks or valve seals.

The price below includes the cylinder heads, valves, valve spring cup locators, water outlet nipples, pushrod guide plates and a set of intake gaskets made specifically for these heads. Also included at no additional charge is an Edelbrock Victor 4150 style intake manifold that has been port-matched for these heads. Water cross-over has been separated from the intake manifold and is included.

I will not separate the intake from the cylinder heads.

I will be asking $1900.00 firm for the heads (as stated above) and the Victor 4150 style intake (included) that has been port-matched to these heads. Also included are the port molds and flow charts to the new owner.

Money order or Bank check only. No person-to-person payments (aka PayPal). I will ship once funds are received. Buyer to pay shipping from zip code 60047.

I have many good seller experiences aligned with items I have sold here. Look in the archives and solicit feedback from those buyers if needed.

[Apache Warrior]

Correction - 1.77 exhaust valve size, not 2.11.

I will officially post these for sale on 5/1 with more details and pictures.

Pat