The Project
Another Pontiac saved and on the road again
Getting close to completion after HOW MANY YEARS?
Nice tail panel trim compliments of my driver
20150405 081232
Tight
After 19 years, motor and tranny are back in car
Muncie m23 fit like a glove after dealing with a oil journal on the throwout bearing
Flywheel and clutch assembly installed.  Original b&b pressure plate and kevlar 26-spline clutch plate
Bellhousig within spec.  0.0045
Ready for the 421
20140816 133753
716 heads ported by SD Performance
Color sanding and buffing.  Looks incredible.  This car could easily have been painted black.  Straight!
Factory 1c-7d c/r t10 is beiing replaced with an autogear m23 drag race w/r.  Noticable differences.  Supercase. Midplate.  3.25" dia tail housing vs...
Lots of progress this week  fit good.  Getting the top body line from doors to front of fenders definitely a challenge
Is that cameo ivory on the firewall?
A holy grail oem wheel. Havent decided if it will be painted red or left original.
Every piece of stainless has been cleaned, scratches removed and polished.  Many hours went into this task
D/s qtr skin installed from two donors.
P/s qtr and outer wheelhouse repaired with donor sections from az
Really nice to see paint... even if its underneath
Wheelhouse repair complete
The next time she sits in this driveway, it'll be in paint.
Ready for cut and tack
tripower linkage reference from carb restorer.  my otc gm linkage is shown at the bottom. carbs now using top linkage out of safety concerns.
Mocking up engine for a visit by the original owners.  Mom and dad
 

All times are GMT -4. The time now is 06:10 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017