fuel line conversion for a sbc to pont swap

[BradZZ]

If I switch from a stock 305 sbc to a pont 400
what is the best way to handle having the fuel pump on the opposite
side of the engine block:
1 run a line from the old steel feed line under the oil pan.
2.run a whole new line specific for the pont
or is there a different idea?
It's for an 86 Gp Thanks

[10874477]

I ran mine under the pan up near the front balancer with three straps and used the pan bolts to put the straps on with

[BradZZ]

Thanks
sounds like the easiest route is the best.
I hadn't thought of mounting right to the pan but makes since.
instead of on the frame rail.

[limejudge69]

I just did this on my 67 Bird. Go to Autozone and buy a 3 foot length of 3/8" steel brake tubing. Buy a tubing bender (also at Autozone) for about 12 dollars. Get a coat hanger and get under the car. Bend the coat hanger to the right size/shape/bends that you need. Then bend the new tube with the bender and install. All you'll need is a small it of rubber hose to connect to the other lines. Works like a champ!