Keith Vrabec
11-03-2009, 07:50 AM
Needed a piece of frame for a project, so had to cut a decent frame. I used the left front frame rail from trans crossmember foward, and cut the motor mounts off the front crossmember.
RIght side isintact, some minor damage to rear crossmember at center where car was pulled with a chain.
RIght side frame rail is good, boxed like convertible.
send email of pic of what you need
slowwrench@ezlinx.net
RIght side isintact, some minor damage to rear crossmember at center where car was pulled with a chain.
RIght side frame rail is good, boxed like convertible.
send email of pic of what you need
slowwrench@ezlinx.net