Conversation Between gtofreek and HJones1313
Showing Visitor Messages 1 to 5 of 5
-
-
Did you get the PM I sent yesterday?
-
I just your messages and Paul, but didn't get any notifications. I'm going to read the springs one, and as far as the other message, I can't thank you enough, you're too kind.
Sincerely,
Howie
-
Hi, have you received the PM's I sent you regarding your valve springs, and lifters? Not sure if the PM system is working.
-
Morning Paul. Sorry to impose on your time, but you obviously exceed my knowledge of Pontiac V8's, and I'm hoping you could answer another couple of questions regarding valve selection. First, I'm unsure of the cut on the valve seats, and which valves to get. I'd like to use Ferrea 5000 series valves, but what length, given my cam selection and #62 heads? Also 7 or 10 degree locks? Regarding your recommendation to use 994 springs, is machining still required. I sold all my stock valvetrain parts. including springs, valves, retainers etc; I don't have valves to measure for length or stem size. If you don't have time to answer I fully understand, but I find when you post a public question on the forums, the variety of answers become overwhelming, and I'd rather get the info form someone who's "been there, done that"!!
Regards,
Howie