Tom63LeMans Tom63LeMans is online now

Senior Member

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. 65madgoat
    07-28-2021 12:05 PM
    65madgoat
    Right on Tom. And if your heads are better, or cost more than my setup, I would be open to paying the difference of course etc. I do have the thicker pushrods my heads were spec'd for too. And I was going to run shaft rockers on these heads... still retaining the shaft rockers though.

    USCJRT@aol.com

    Thanks.

    John
  2. Bill Eveland
    03-04-2019 04:27 PM
    Bill Eveland
    I just use a crossmember now. Just a short piece that sits on top of bottom ledge of x frame

About Me

  • About Tom63LeMans
    Cars
    1963 Lemans street/strip car, ‘56 Chieftain gasser
    Biography
    I was born with a 9/16" wrench in my hand. Grew up at family owned gas station in Parma, Oh.
    Location
    Northeast Ohio
    Interests
    Pontiacs, Drag racing and hiking.
    Occupation
    Retired
  • Signature
    Tom

    1963 Lemans -428 +.030, SD Perf KRE heads, turbo 350, 9" Ford 3:90, 11.01@121

    1956 Chieftain gasser, 461 stroked 400, SD Perf ported E-heads, turbo 400, Dana 3:70 10.40@125

Statistics

Total Posts
Albums
Visitor Messages
Total Thanks
General Information

All times are GMT -4. The time now is 09:03 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017