mgarblik mgarblik is offline

Ultimate Warrior

Visitor Messages

Showing Visitor Messages 1 to 8 of 8
  1. taktikian
    11-18-2020 04:39 PM
    taktikian
    Just got back from my machine shop and they want to put one sleeve on my 455 block. This would require a 4.3 something bore to accept that sleeve. They assure me it's okay but I am skeptical since a .60 overbore is usually considered not good from what I gather here. I do not think he has sonic testing equipment . You seem to be very knowledgeable on matters such as this and I would certainly appreciate any input you are willing to provide. The owner of the shop is very nice but somewhat casual-says he does it all the time. He mostly builds high end truck pulling motors. Any opinion would be greatly appreciated. Thanks,Paul
  2. mgarblik
    02-07-2018 09:43 PM
    mgarblik
    That number sounds possible. I will look tomorrow
  3. 73 TRANSAM
    02-07-2018 09:30 PM
    73 TRANSAM
    I need a NGK R5671A-8. if you have these and how many set. Let me know, thanks.
  4. tempest1964
    11-18-2016 10:57 PM
    tempest1964
    Mike, I posted some pictures of a set of 3.23 gears in the 64-65 section. With your background, could you give me your opinion if they look ok? I'm not really well versed in gears and what looks ok.
    Thanks
    Tony
  5. tempest1964
    10-24-2015 10:22 AM
    tempest1964
    I went to Sinclair, receiving an Assoc. Deg. while working at GM/Delphi to complete my apprenticeship. Grew up in Dayton, Belmont HS. Just curious, what is your name? Just wonder if I ever had you as an instructor.
    Tony Bulcher
  6. mgarblik
    05-25-2015 04:11 PM
    mgarblik
    .800 maximum valve lift with a 2.00 installed height.
  7. mgarblik
    05-25-2015 04:02 PM
    mgarblik
    I would sell a set for 300.00. But at 2.00, that's a short installed height. You would have a little over 400 PSI on the seat. What is your rocker ratio? You may run out of spring with that short installed height.
  8. 73 TRANSAM
    05-25-2015 11:24 AM
    73 TRANSAM
    I am just curious, how much are you asking for the spring? I have the dual spring from comp cam 1.645 od with the 250 @ 2.00 installed height. My cam has a .450 lobe lift 55mm. It is a turbo setup on Butler W. P. eheads. Thanks.

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: Today 11:10 AM
  • Join Date: 03-05-2005
  • Referrals: 2

Friends

Showing Friends 1 to 3 of 3

All times are GMT -4. The time now is 11:13 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017