3250 and you pick up I paid over 4500 for everything and you get it all KRE high ports with 45 degree surti valve job. Double back cuts are 22 degrees and 11 degrees. The exhaust seats has been radiused with a Nascar type valve job. I had the combustion chambers relieved around the valves using a special cutter from Mondello Performance. The push rods are custom and made by COMP for a stock block. They cost me $195.00. They are 3/8's that shrink down to allow you to use a 5/16 roller lifter and roller rocker. I have custom KRE braces and ARP studs to add stability to the drive train. The heads have over 20 hours of port work. The Victor intake cost me $380 and has $300 worth of port work. Everything is matched ported. The heads have been professionally evaluated and flowed by Wilson's manifold and recommendations and changes were made to attain max horsepower with my combo. The new springs were installed at 2.050 install height because of the longer valve. The seat pressure is 233 open pressure is 735. You also get my ARP engine studs to ensure proper sealing. You can use kre 380 cfm gaskets for the intake the are matched with the right set up and the work we have recently done. They could make 825 HP with the right set up. This is a gift and in another month it will be tax time and I will definitely do everything I can to get my money back then if you don't buy them.

I have been racing Pontiacs for about 20 years now and it kills me to part with these heads because I know the time that was put into them. I would love to see you buy them and keep in touch with me so that I can hear about how fast you're going. Let me know