Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 2 1 2
Showing results 1 to 25 of 45
Search took 0.03 seconds. Search: Posts Made By: RocktimusPryme
Forum: Tri-Power Tech 08-26-2024, 11:12 PM
Replies: 8
Views: 1,337
Posted By carbking
Tag on center carb crosses to a 1961 Oldsmobile...

Tag on center carb crosses to a 1961 Oldsmobile 394 service carburetor, produced in March of 1964.

Jon
Forum: THE LOBBY 08-01-2024, 07:10 PM
Replies: 13
Views: 993
Posted By Mr Twister
I'm going through this today. some amazing...

I'm going through this today. some amazing treasure and some, what was he thinking.
Forum: Pontiac - Street 07-31-2024, 04:26 PM
Replies: 14
Views: 497
Posted By Radman
Gasket or grommet around the dipstick. When...

Gasket or grommet around the dipstick. When running the torque converter will fill up. After sitting an extended time it will drain back into the transmission. The fluid level will be higher than...
Forum: Pontiac - Street 07-31-2024, 02:52 PM
Replies: 14
Views: 497
Posted By geeteeohguy
Gravity drain might be exacerbated by converter...

Gravity drain might be exacerbated by converter drain-back after she sits.
Forum: Pontiac - Street 07-31-2024, 11:24 AM
Replies: 14
Views: 497
Posted By steve25
I would investigate the return line adapter on...

I would investigate the return line adapter on the trans and the flare of that line itself.
Forum: Pontiac - Street 07-26-2024, 10:47 PM
Replies: 11
Views: 1,259
Posted By Cliff R
The website is down for the moment. May take a...

The website is down for the moment. May take a while to sort it out. They were sending payment notifications to the wrong email address so it expired. Best to call me at the shop until we get...
Forum: Pontiac - Street 07-24-2024, 07:23 PM
Replies: 13
Views: 611
Posted By b-man
For hard use you don’t really want a grease...

For hard use you don’t really want a grease fitting creating a weak spot in the stressed corner of the joint.

If you do have a joint with a grease fitting it should be installed such that it’s...
Forum: 61-66 Big Pontiac TECH 07-12-2024, 05:15 PM
Replies: 5
Views: 424
Posted By jamesq
Here is the latch adjustment procedure from my 63...

Here is the latch adjustment procedure from my 63 manual, it should be similar.

James Q
Forum: EFI Tech 07-03-2024, 11:57 PM
Replies: 7
Views: 516
Posted By krisr
Crank sensor is above the starter motor on all LS...

Crank sensor is above the starter motor on all LS motors. The cam sensor moved to the timing cover in Gen4's, the Gen3 LS1 is up the back behind the intake. As long as the camshaft core is for a...
Forum: The Body Shop TECH 06-14-2024, 09:23 PM
Replies: 13
Views: 1,232
Posted By jamesq
I have used them and they will mix up whatever...

I have used them and they will mix up whatever you need in single stage. They did this for my interior paint. Contact them by phone and ask.

Good luck,
James Q
Forum: THE LOBBY 05-22-2024, 11:50 PM
Replies: 24
Views: 1,601
Posted By bhill86
Lol you’re speaking my language. Looks like John...

Lol you’re speaking my language. Looks like John Milner wins for now though. By the way, whether we want to admit it or not I believe we’re technically the “M” word.
Forum: Pontiac - Street 04-10-2024, 04:38 PM
Replies: 30
Views: 4,291
Posted By Singleton
I've had the small cap Progression distributor...

I've had the small cap Progression distributor for a couple years now, no issues with it in about 7-8k miles. I regularly use the anti-theft feature from the phone app when out and about, and when...
Forum: Pontiac - Street 03-24-2024, 02:54 PM
Replies: 23
Views: 2,160
Posted By ZeGermanHam
I bought the aluminum pulleys from Ram Air Resto....

I bought the aluminum pulleys from Ram Air Resto. Took about a year to receive them at the time, but they work great on my 66 with PS, AC, high flow WP, and HD fan clutch. Gates belts, no squeal...
Forum: Pontiac - Street 02-09-2024, 09:35 PM
Replies: 104
Views: 11,039
Posted By Gach
Definitely!

Definitely!
Forum: Electrical Tech 01-03-2024, 07:43 PM
Replies: 14
Views: 2,024
Posted By mgarblik
Before you test your parts car wiper motor, I...

Before you test your parts car wiper motor, I suggest you open it up and inspect it. They pack those old assemblies with grease that is almost solid now after 50+ years. Just cleaning the poor...
Forum: Pontiac - Street 12-20-2023, 02:31 PM
Replies: 20
Views: 1,542
Posted By GoatZillaRacing
Comp Cams recommends these too. They actually say...

Comp Cams recommends these too. They actually say not to use a composite gear with a high pressure pump. I've never had a composite gear fail but I must admit, these feel safer to install and they...
Forum: THE LOBBY 12-18-2023, 04:21 PM
Replies: 50
Views: 7,547
Posted By locomotivebreath
Jorts & white socks ! Man I hope that doesn’t...

Jorts & white socks ! Man I hope that doesn’t happen to me .
Forum: Pontiac - Street 12-06-2023, 05:05 PM
Replies: 18
Views: 1,597
Posted By JLMounce
Okay, so based on this, you're after a bit more...

Okay, so based on this, you're after a bit more repeatability.

Going to a disc setup in the rear will help some, but not as much as you likely need. These cars do most of their braking from the...
Forum: Pontiac - Street 11-08-2023, 06:23 PM
Replies: 79
Views: 6,533
Posted By JLMounce
This. These cars didn't drive terribly when new....

This. These cars didn't drive terribly when new. When I hear people say you should throw a rack and pinion in them because they drive like crap otherwise just tells me they drove a 50+ year old car...
Forum: Pontiac - Street 10-27-2023, 03:31 PM
Replies: 23
Views: 1,947
Posted By OG68
Perhaps fuel is sloshing out of your vent hose...

Perhaps fuel is sloshing out of your vent hose when hard braking / accelerating.
Ames has a vent hose with a filter that may restrict fuel slosh

https://www.amesperf.com/parts/36579/
Forum: Pontiac - Street 10-27-2023, 02:26 PM
Replies: 23
Views: 1,947
Posted By ID67goat
Just some feedback…….After installing basically...

Just some feedback…….After installing basically the same setup as you (Sniper, tanks inc, etc) I basically have no fuel smell in my garage anymore. Are you sure there is not a small leak somewhere...
Forum: Pontiac - Street 10-27-2023, 01:21 PM
Replies: 23
Views: 1,947
Posted By Scarebird
I simply ran the vent tube line from the...

I simply ran the vent tube line from the fuel/vapor separator to the charcoal cannister, then into the airbox.

This is with fuel injection.
Forum: Pontiac - Street 10-26-2023, 11:58 PM
Replies: 23
Views: 1,947
Posted By Mister Pontiac
One other thought, Rocktimus... My 74 Bonne...

One other thought, Rocktimus...

My 74 Bonne has the canister and full setup you're describing, and it does not smell near as bad as all my other Pontiac's.

But the other thing it has is an...
Forum: THE LOBBY 08-10-2023, 11:59 AM
Replies: 27
Views: 1,646
Posted By Greg Reid
22 y.o. me and my 22 y.o....

22 y.o. me and my 22 y.o. Caddyhttps://uploads.tapatalk-cdn.com/20230810/af1ecf42922847efc959890c413641a2.jpg

Sent from my moto g stylus (2021) using Tapatalk
Forum: 61-66 Big Pontiac TECH 06-19-2023, 06:58 PM
Replies: 14
Views: 1,583
Posted By mgarblik
Yes, car-part.com is just a huge internet junk...

Yes, car-part.com is just a huge internet junk yard. But there was one yard that had 6-8 of them for $50.00. The notes said "tested" I have no real idea what that means. If I bought a wrecking...
Showing results 1 to 25 of 45
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 06:36 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017