Showing results 1 to 24 of 24
Search took 0.01 seconds.
Search: Posts Made By: Big Bear
Forum: THE LOBBY 11-22-2023, 08:41 PM
Replies: 3
Views: 427
Posted By Big Bear
Watched the Vega video last night. Looks like a...

Watched the Vega video last night. Looks like a local car that was around when I was a kid. The difference is it not only has the look but drives, stops well and has more power than in the day. They...
Forum: The Body Shop TECH 10-19-2023, 09:36 AM
Replies: 4
Views: 629
Posted By Big Bear
Have been using hot rod black on the last few...

Have been using hot rod black on the last few cars. Has more gloss than the 60% most use but I like the look. Used HRB on dash top and rear glass trim on first car. Had too much reflection on the...
Forum: Pontiac - Street 10-16-2023, 12:36 PM
Replies: 12
Views: 707
Posted By Big Bear
Had same problem. Used a 5 gallon plasic oil...

Had same problem. Used a 5 gallon plasic oil bucket. It already ate through a metal bucket. Why use another?
Forum: Pontiac - Street 10-01-2023, 09:52 AM
Replies: 194
Views: 13,525
Posted By Big Bear
This oil pump was posted on e-bay some time ago.

This oil pump was posted on e-bay some time ago.
Forum: The Body Shop TECH 03-02-2023, 07:45 PM
Replies: 8
Views: 1,301
Posted By Big Bear
The spatter is larger than a spray can.

The spatter is larger than a spray can.
Forum: THE LOBBY 12-18-2022, 11:17 AM
Replies: 19
Views: 1,200
Posted By Big Bear
Clinic prescribed indomethacin. It would normally...

Clinic prescribed indomethacin. It would normally subside within a day after taking it.. Been taking Uric Cleanse from the health food store daily for a few years along with watching the diet and...
Forum: 77-81 Firebird & Trans Am TECH 12-15-2022, 10:15 AM
Replies: 17
Views: 2,003
Posted By Big Bear
His other add under Other Pontiacs for sale. ...

His other add under Other Pontiacs for sale. 1977 Pontiac Can Am Parts Parts Parts...Whole cars with drivetrain and titles $2500 I am located in Lowell Indiana can call or text if...
Forum: 68-69 GTO Tempest & LeMans TECH 11-29-2022, 10:57 AM
Replies: 10
Views: 1,637
Posted By Big Bear
I am having one other problem when I put the air...

I am having one other problem when I put the air cleaner on and drive the car. I have a Holley 750 carb on the car and the idle goes up. I don't know if it is because the bottom of the pan is hitting...
Forum: 67-81 Firebird & TA Parts WANTED 10-21-2022, 11:23 AM
Replies: 10
Views: 1,291
Posted By Big Bear
Our local NAPA was able to get a repop skin for...

Our local NAPA was able to get a repop skin for me. Front fender alignment was good but center crease at rear was low 3/8". I'm sure there are better panels out there but factory is probably the...
Forum: 68-69 GTO Tempest & LeMans TECH 05-31-2022, 10:05 PM
Replies: 6
Views: 967
Posted By Big Bear
Dont know if the gun will work on both products....

Dont know if the gun will work on both products. There is only about $6 between the two products and 3M is a good product. Wouldnt change brand and chance the gun not working if I already have the 3M...
Forum: The Body Shop TECH 03-03-2022, 09:02 PM
Replies: 8
Views: 801
Posted By Big Bear
Using the black plastic guards. Hold them on with...

Using the black plastic guards. Hold them on with miniture c-clamps. Makes them easy to remove.
Forum: Pontiac - Race 02-07-2022, 11:43 AM
Replies: 24
Views: 3,908
Posted By Big Bear
Rich Guido at Sick Week

Made the 3400 mile trip to start Sick Week https://youtu.be/7U9D1iAgh6I
Forum: 77-81 Firebird & Trans Am TECH 01-15-2022, 10:53 AM
Replies: 17
Views: 2,760
Posted By Big Bear
Went and did some measuring. 76 th350-48.5", 78...

Went and did some measuring. 76 th350-48.5", 78 st10-48", 70 th400+12 bolt rear-48".
Forum: The Body Shop TECH 01-02-2022, 11:11 AM
Replies: 4
Views: 1,072
Posted By Big Bear
Raise it high enough to clear the lower bar.

Raise it high enough to clear the lower bar.
Forum: THE LOBBY 12-22-2021, 03:10 PM
Replies: 8
Views: 1,768
Posted By Big Bear
Had a LeRoi compressor that had a six cylinder...

Had a LeRoi compressor that had a six cylinder block. Four cylinder gas engine, two cylinder compessor. Engine had a four inch bore, the compressor was six inch. It was made around 1947-48. Worked...
Forum: 74-76 Firebird & TA TECH 11-12-2021, 02:21 PM
Replies: 5
Views: 1,394
Posted By Big Bear
Check out [SD-455 coming to shop next month] post...

Check out [SD-455 coming to shop next month] post in the 74-76 firebird tech. It shows pictures of a original 74 TA.
Forum: 66-67 GTO Tempest & LeMans TECH 08-24-2021, 04:48 PM
Replies: 15
Views: 3,983
Posted By Big Bear
Try the fix that chrisp mentioned. Cut the hot...

Try the fix that chrisp mentioned. Cut the hot water to the heater core is a start.The rubber on your dampers in the heater housing might be toast. If your in Socal that heat could cook any soft...
Forum: The Body Shop TECH 04-19-2021, 08:53 AM
Replies: 20
Views: 2,645
Posted By Big Bear
https://youtu.be/-yA8q4K-_Bo Check out link. ...

https://youtu.be/-yA8q4K-_Bo Check out link. Tested products various ways. Cant go wrong with blasting,epoxy and top coat with two part urethane.
Forum: 70-73 Firebird & TA TECH 02-18-2021, 12:28 PM
Replies: 12
Views: 963
Posted By Big Bear
Just finished this alignment with my car. You...

Just finished this alignment with my car. You really have to assemble the hood and nose to even the gaps on all panels. In your picture it looks like the front of the fender should go in. That would...
Forum: 67-69 Firebird TECH 01-17-2021, 09:05 PM
Replies: 17
Views: 4,689
Posted By Big Bear
Installed one in a second gen bird. 200 and 350...

Installed one in a second gen bird. 200 and 350 are the same length so a complete drive shaft and yoke from a th350 would work. The oil pan is longer and the mount is farther back so I used a spare...
Forum: Pontiac - Street 07-09-2020, 12:35 PM
Replies: 7
Views: 1,619
Posted By Big Bear
My car is a 80 with a cover plate. Made a bracket...

My car is a 80 with a cover plate. Made a bracket with a cabinet hinge so it flips up and stays. Mounted radio behind it.
Forum: Interior TECH 04-08-2020, 10:57 PM
Replies: 11
Views: 2,208
Posted By Big Bear
If rubbed on it will dull to silver look but not...

If rubbed on it will dull to silver look but not chipping off. I did it free hand taking long strokes. No masking. When liquid it flows and stays on the raised lip. If it does'nt turn out the first...
Forum: THE LOBBY 03-18-2020, 10:43 PM
Replies: 62
Views: 5,046
Posted By Big Bear
Here are a couple of 409 Pontiacs....

Here are a couple of 409 Pontiacs. https://youtu.be/zORc_7lxq4s https://youtu.be/VFdLeRT3pWg
Forum: 77-81 Firebird & Trans Am TECH 02-17-2020, 09:15 PM
Replies: 19
Views: 2,381
Posted By Big Bear
The TA looks gr8. Summer is around the corner. We...

The TA looks gr8. Summer is around the corner. We have been enjoying our 80 TA 4bbl for 28 years. Like you said it's a little underpowered but makes a nice cruiser. Enjoy the new toy.
Showing results 1 to 24 of 24

 
Forum Jump

All times are GMT -4. The time now is 11:54 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017