Showing results 1 to 15 of 15
Search took 0.05 seconds.
Search: Posts Made By: Doug
Forum: Pontiac - Street 10-04-2021, 08:36 PM
Replies: 13
Views: 2,131
Posted By Doug
Smile CUT IT?

I did! Left enough of a tab where your index finger is pointing to latch up between block and bellhousing.
Forum: Pontiac - Street 09-10-2021, 09:48 AM
Replies: 27
Views: 3,779
Posted By Doug
1. scotch block car to keep it from rolling 2....

1. scotch block car to keep it from rolling
2. make sure ALL wires are disconnected
3. disconnect speedo cable and back-up switch wire from tranny
4. grease up the threadbar on the tilter
5....
Forum: 66-67 GTO Tempest & LeMans TECH 07-12-2021, 02:20 PM
Replies: 699
Views: 177,389
Posted By Doug
Smile 67 Lemans

Have had this for 6 yrs.

77 400ci
200R4
ps, pb-front discs
posi
Vintage Air
Forum: National Events 03-06-2021, 01:36 PM
Replies: 81
Views: 38,534
Posted By Doug
Question norwalk

Norwalk is where the Cedar Point Amusement Park visitors flock to for motels/hotels. Their peak season is about the same times as AMES. The rates are jacked up because of that. Better get your...
Forum: THE LOBBY 11-12-2020, 05:41 PM
Replies: 10
Views: 1,502
Posted By Doug
My barn find event happened about 25 years ago....

My barn find event happened about 25 years ago. One evening at dusk I was driving home with my wife and I was astonished to see a rollback come past me in traffic with a car on it. I screamed out to...
Forum: Tri-Power Tech 03-02-2020, 06:38 PM
Replies: 26
Views: 21,115
Posted By Doug
Avman, I assume your tires are about 25.6 or...

Avman,
I assume your tires are about 25.6 or 25.8 inches in diameter and you made a typo when you said the rear axle ratio was 3.80 when it is actually a 3.08 ratio. (A 3.80 ratio seems strange for...
Forum: THE LOBBY 02-10-2020, 06:18 PM
Replies: 46
Views: 2,694
Posted By Doug
Thumbs down right lane is roughest pavement-broken up by...

right lane is roughest pavement-broken up by trucks
Forum: 64-65 GTO Tempest & LeMans TECH 02-01-2020, 08:19 PM
Replies: 15
Views: 2,639
Posted By Doug
Smile rear ratio?

2.93 to 1 for 326 2bbl automatic with AC
Forum: Pontiac - Street 10-02-2014, 01:53 PM
Replies: 1
Views: 151
Posted By Doug
The instruction sheet on a new PRW 45570 flywheel...

The instruction sheet on a new PRW 45570 flywheel I just installed reads:

Step 9- "...Place a dial indicator on the clutch housing, mounting it so the button of the indicator makes contact with...
Forum: 61-63 Tempest & LeMans TECH 01-04-2014, 11:31 AM
Replies: 11
Views: 1,262
Posted By Doug
Thumbs up "The Tempest That Would Be King!"

For those who may not have seen this when I posted it a while back:
Forum: 64-65 GTO Tempest & LeMans TECH 12-09-2013, 01:56 PM
Replies: 9
Views: 539
Posted By Doug
Cool gasketing?

While there typically aren't issues it seems that use of the new reproduction "aluminum" tri-power manifold(s) may have some issues of port alignment, etc. that require you to pay closer attention to...
Forum: 66-67 GTO Tempest & LeMans TECH 12-03-2013, 06:31 PM
Replies: 99
Views: 4,317
Posted By Doug
So, if your "fuel line(s) are done, why not do...

So, if your "fuel line(s) are done, why not do the gas tank now? For me, the exhaust system is something you do at the last (assuming your exhaust manifolds are in place).

Wiring? Are you doing a...
Forum: 61-77 GTO, Tempest & LeMans Parts WANTED 11-10-2013, 07:11 PM
Replies: 4
Views: 372
Posted By Doug
Be aware that there are some sets of '65...

Be aware that there are some sets of '65 upholstery that have the patterns of both the front and back seats "reversed"' One of the aftermarket suppliers apparently had a run of these incorrect covers...
Forum: 61-63 Tempest & LeMans TECH 10-23-2013, 09:17 PM
Replies: 42
Views: 3,825
Posted By Doug
Cool "sliders" and shackles

I looked into "sliders" for my project. Biggest drawback was that my Mopar HD springs have a long rear section that ends right at about where the subframe rail turns upward creating a curved section...
Forum: 61-63 Tempest & LeMans TECH 10-23-2013, 04:08 PM
Replies: 42
Views: 3,825
Posted By Doug
Question conversion confusion?

I have followed this thread casually and hadn't soaked up much details until today. A few things that may be an issue are:

There is some confusion on what your "current" motor is. 326? or 389? The...
Showing results 1 to 15 of 15

 
Forum Jump

All times are GMT -4. The time now is 09:30 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017