Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 2 1 2
Showing results 1 to 25 of 28
Search took 0.08 seconds. Search: Posts Made By: ggttoo66
Forum: Pontiac - Street 01-29-2022, 05:54 PM
Replies: 17
Views: 2,683
Posted By West Coast GTO
George: I used the manifold vacuum port for...

George: I used the manifold vacuum port for testing engine vacuum, not the timed vacuum port on carb.
Initially the vacuum gauge read LATE IGN TIMING ( between 14 and 18 inches on gauge) and rose...
Forum: THE LOBBY 08-22-2020, 03:34 PM
Replies: 6
Views: 961
Posted By Stuart
Upcoming auction at Fall Auburn with some Pontiacs

This is a link to the Dave Leimbach car collection on the RM auction site:...
Forum: 70-73 Firebird & TA TECH 06-19-2020, 04:58 PM
Replies: 14
Views: 1,571
Posted By Aus78Formula
Lift the rear of the hinge to make the rear of...

Lift the rear of the hinge to make the rear of the hood sit down. Plus, quite possible the hinge is worn out too.
Forum: Pontiac - Street 05-31-2020, 01:05 AM
Replies: 2
Views: 1,047
Posted By Old Man Taylor
The '68 timing cover is the first to go with the...

The '68 timing cover is the first to go with the "4 bolt" balancer, and the last to use an 8 bolt water pump.
Forum: 67-69 Firebird TECH 05-27-2020, 10:08 PM
Replies: 13
Views: 2,612
Posted By Jerry H.
Not the same Tom. This car was painted blue. ...

Not the same Tom. This car was painted blue. Not the supposed first 2. This was new episode.
Forum: THE LOBBY 05-18-2020, 01:47 AM
Replies: 17
Views: 1,353
Posted By NeighborsComplaint
After an eternity at the body shop, I decided to...

After an eternity at the body shop, I decided to forego the ram air pan and such until I get it home and do it myself. I have a Torker II intake and an 800 cfm Jet Stage 2 Qjet to put on when I do...
Forum: THE LOBBY 05-13-2020, 06:18 PM
Replies: 21
Views: 1,933
Posted By Chris65LeMans
I've seen brand new, top-of-the-line Mercedes and...

I've seen brand new, top-of-the-line Mercedes and Rolls Royces sporting the "saving up for a paint job" flat black look.

That mopar makes even less sense.
Forum: 67-79 Big Pontiac TECH 04-02-2020, 10:32 AM
Replies: 19
Views: 3,602
Posted By David Brown
Buy a good rebuild kit. It is pretty easy, just...

Buy a good rebuild kit. It is pretty easy, just keep parts in order and follow the directions. You may also need a new float. I know where to get for Quadrajets but not sure for 2bbls but I would...
Forum: THE LOBBY 02-28-2020, 07:26 PM
Replies: 7
Views: 780
Posted By 1965gp
These used to have 4th gen TA tail lights. Not...

These used to have 4th gen TA tail lights. Not sure if these do or not?
Forum: 67-81 Firebird & TA Parts WANTED 02-11-2020, 09:53 PM
Replies: 1
Views: 831
Posted By Wbyman22
1968 3:36 ZM Rear End

Anybody happen to have one they’d part with?


Sent from my iPhone using Tapatalk
Forum: The Body Shop TECH 01-21-2020, 08:15 PM
Replies: 11
Views: 2,021
Posted By 1965gp
Did you get all of the screws in? Every time I do...

Did you get all of the screws in? Every time I do this I end up having to drop the window some. You can get to a few on each end but the glass usually covers the ones in the center.
Forum: The Body Shop TECH 12-12-2019, 10:52 AM
Replies: 20
Views: 8,775
Posted By 400 4spd.
Greg, I am PMing my number to you in case you...

Greg, I am PMing my number to you in case you don't have it anymore. I can tell you how to cure it.
Steve
Forum: Members Helping Members 12-11-2019, 05:53 PM
Replies: 19
Views: 6,651
Posted By Goatracer1
The spindle is not tapered. It has 1/2 x 24...

The spindle is not tapered. It has 1/2 x 24 threads it's entire length. The chuck had the 3 fingers that held the drill bit. Somehow my grandson lost those. The drill press is in an unheated garage....
Forum: THE LOBBY 11-05-2019, 02:38 PM
Replies: 14
Views: 1,491
Posted By 67drake
And I wasted money on filter wrenches for all these years!

I thought this was a spoof video at 1st, but I don’t know....
https://m.youtube.com/watch?v=QPVs03aZjmc
Forum: Pontiac - Street 08-20-2019, 10:23 AM
Replies: 8
Views: 1,229
Posted By TAQuest
There is a plug near the distrib. base which is...

There is a plug near the distrib. base which is an oil galley plug. It can be removed and used to plumb an oil pressure gauge into. It is possible the plug may be slightly loose or not seated enough...
Forum: 61-77 GTO, Tempest & LeMans Parts For SALE 11-24-2018, 09:22 PM
Replies: 1
Views: 400
Posted By lugnutx2
65-67 hood scoop insert

GM piece, I used the studs on my car, previous owner was going to make it ram air and made 1 cut as shown in top left of picture. The cut should be EZ to fill, repair won't be seen when installed....
Forum: THE LOBBY 07-30-2017, 07:38 PM
Replies: 37
Views: 2,629
Posted By NeighborsComplaint
I knew a transmission shop owner that had an...

I knew a transmission shop owner that had an Accura they rebuilt twice and it failed both times while under warranty. Their solution was to get a junkyard transmission, paint it, and put it in and...
Forum: 64-65 GTO Tempest & LeMans TECH 01-25-2017, 10:51 PM
Replies: 19
Views: 1,416
Posted By John V.
Tom may have forgotten, but his KC convertible...

Tom may have forgotten, but his KC convertible was equipped with the Verbra-Phonic rear seat speaker from the factory as confirmed by the 5 Group Code 2V on his Data Plate.

Since the decode of the...
Forum: Pontiac - Street 07-22-2016, 04:35 PM
Replies: 19
Views: 1,094
Posted By JLMounce
For what it's worth, I'm looking at my ARP studs...

For what it's worth, I'm looking at my ARP studs for me KRE's right now. The instructions don't state to retorque. The instructions want 110 ft lbs with the supplied lube.

I talked with Jeff...
Forum: 67-79 Big Pontiac TECH 06-06-2016, 12:34 PM
Replies: 467
Views: 129,731
Posted By Diego
I don't remember anything else than that, other...

I don't remember anything else than that, other than it needed a resto. Can't remember where I saw the car but prob Hemmings.

From what I've seen at the GM Heritage Center, there are no records....
Forum: Electrical Tech 05-31-2016, 11:49 AM
Replies: 2
Views: 169
Posted By "QUICK-SILVER"
Take the flasher out and see if the fuse still...

Take the flasher out and see if the fuse still blows.

IF IT DOES, the pink wires that power stop light and flasher are shorted to ground somewhere.

IF IT DOESN'T, the short is in the purple...
Forum: Pontiac - Street 09-17-2015, 04:42 PM
Replies: 3
Views: 244
Posted By Bill Eveland
You might try tapping on the pitman arm shaft ,...

You might try tapping on the pitman arm shaft , it may be stuck some in the adjusted position you put it at.
Forum: Pontiac - Street 11-07-2014, 02:55 PM
Replies: 66
oil
Views: 2,868
Posted By Formulajones
Adam, Higher loading on the valvetrain is...

Adam,
Higher loading on the valvetrain is referring to camshafts with agressive ramp profiles, higher springs pressures and the like. It's not realy refering to flat tappet vs roller, since both...
Forum: 67-69 Firebird TECH 05-26-2014, 08:42 PM
Replies: 4,157
Views: 669,134
Posted By thews
eBay sightings

I watch eBay a lot and it seems pointless to start new threads when things pop up. These two are worthy:

1969 Firebird convert 4-speed. I have a Palladium silver 350HO convert 4-speed car and I...
Forum: 66-67 GTO Tempest & LeMans TECH 03-30-2013, 12:36 AM
Replies: 14
Views: 507
Posted By Baron Von Zeppelin
The old dual piston calipers from 67 and 68 i...

The old dual piston calipers from 67 and 68 i think were the ones that could cause interference with some 14" wheels.

They used 2 different Rally2 codes in 67-68 depending if it was drum or disc.
Showing results 1 to 25 of 28
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 08:09 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017