Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Showing results 1 to 12 of 12
Search took 0.01 seconds. Search: Posts Made By: GTO.PAUL
Forum: 66-67 GTO Tempest & LeMans TECH 02-26-2024, 12:46 PM
Replies: 10
Views: 501
Posted By GTO.PAUL
Trunk Weather Strip Joint

Time for a essay on the correct way, and why, on trunk weatherstrip installation. I have studied this on many salvage yard GTO/LeMans and my originals. The two pre-marked grease pencil stripes on the...
Forum: 66-67 GTO Tempest & LeMans TECH 02-19-2024, 07:19 PM
Replies: 17
Views: 992
Posted By GTO.PAUL
Hood Scoop

I have a NOS scoop and can add some pics when I next get a chance for that. It is red oxide primer with the scoop "Air Inlet" section already blacked out. Paul
Forum: 70-73 Firebird & TA TECH 06-09-2023, 09:35 AM
Replies: 4
Views: 1,069
Posted By GTO.PAUL
Date Stamps

I have not looked at all year Bird and GTO fenders. What I have seen is on '69 Birds, the stamp is buy the front on the vertical engine compartment side, usually by the spot welds. On the '68/'69...
Forum: 70-73 Firebird & TA TECH 06-05-2023, 11:24 AM
Replies: 4
Views: 1,069
Posted By GTO.PAUL
Hood Dates

Those are May 12th and May 16th. The letter characters I have not been able to figure out, maybe stamping machine, shift etc? The rear bumpers and front fenders also have this same sequence for...
Forum: 68-69 GTO Tempest & LeMans TECH 09-13-2022, 08:01 AM
Replies: 8
Views: 848
Posted By GTO.PAUL
Washer Nozzel

I believe you have a '70 hood. That year washer squirter used a tab that went into the square hole and a single screw into the round hole. It was a savings of two screws per hood and the time to put...
Forum: 61-77 GTO, Tempest & LeMans Parts WANTED 06-20-2022, 09:37 AM
Replies: 4
Views: 910
Posted By GTO.PAUL
Trim

All 5 pieces will be sent today. Thanks, Paul
Forum: 68-69 GTO Tempest & LeMans TECH 04-14-2022, 12:44 PM
Replies: 23
Views: 1,927
Posted By GTO.PAUL
Wire Mesh Screen

Assembly manual pics and Arlington screw used to retain mesh screen.
Forum: 68-69 GTO Tempest & LeMans TECH 04-14-2022, 12:35 PM
Replies: 23
Views: 1,927
Posted By GTO.PAUL
'69 Cowl Screen Details

First off, let me begin by saying that this clip should be referred to as an "I" clip, not an "H" clip. When properly installed (in the middle area of the row of oval slots at the base of the lower...
Forum: THE LOBBY 08-21-2021, 11:27 AM
Replies: 15
Views: 2,726
Posted By GTO.PAUL
GTO Heaven

Hi everyone! I thought I would respond to my fellow forum folks. A little background, my neighbor friend, Ben, had wanted to get Richard to my GTO hangout for a while. I thought "no harm in that",...
Forum: 68-69 GTO Tempest & LeMans TECH 05-08-2021, 10:38 AM
Replies: 24
Views: 5,962
Posted By GTO.PAUL
Headlight Door Tab

I looked at 6 sets of original hideaways 3-'68 and 3-'69, and all had the 90 degree bend at the top of the tab as shown.
Forum: 70-72 GTO Tempest & LeMans TECH 04-16-2021, 09:32 PM
Replies: 9
Views: 1,830
Posted By GTO.PAUL
Fuel Vent Filter

Just go get a lawnmower foam filter element(usually a light green color) and cut it close to the size you need and press in and reinsert the staple. You now have dust protection and a filter that can...
Forum: 66-67 GTO Tempest & LeMans TECH 04-02-2021, 10:45 AM
Replies: 10
Views: 1,179
Posted By GTO.PAUL
'67 holes

I believe the answer is: They are for your back-up lights. The feed wire to them goes through those holes and a gray rubber grommet that is on the back-up light wire fits in there. Hope that helps,...
Showing results 1 to 12 of 12

 
Forum Jump

All times are GMT -4. The time now is 04:00 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017