Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 2 1 2
Showing results 1 to 25 of 34
Search took 0.02 seconds. Search: Posts Made By: TedRamAirII
Forum: Pontiac - Street 03-29-2024, 07:55 PM
Replies: 23
Views: 1,020
Posted By TedRamAirII
Hook your timing light to the coil wire, strobe!

Hook your timing light to the coil wire, strobe!
Forum: Pontiac - Street 03-24-2024, 07:44 PM
Replies: 67
Views: 2,545
Posted By TedRamAirII
I would pull the valve covers and check valve...

I would pull the valve covers and check valve springs ASAP.
Forum: Pontiac - Street 12-18-2023, 09:18 PM
Replies: 25
Views: 3,515
Posted By TedRamAirII
You should be able to pull the fuel pump out and...

You should be able to pull the fuel pump out and look at the front of the block see if there's a huge oil leak at the front of the block.
Forum: Pontiac - Street 12-18-2023, 09:13 PM
Replies: 84
Views: 9,648
Posted By TedRamAirII
Sorry I didnt go back that far. You say it lost 1...

Sorry I didnt go back that far. You say it lost 1 volt under load at the Red wire at the switch, thats not good. You dont want any voltage loss. You want a full 12V at the purple wire, A good charged...
Forum: Pontiac - Street 11-12-2023, 10:01 AM
Replies: 816
Views: 64,456
Posted By TedRamAirII
i would want the initial and total to be where...

i would want the initial and total to be where you want them to be. Mechanical needs to be limited by narrowing the slot. I think total with vacuum advance usually ends up near 50btdc.
Forum: Pontiac - Street 05-28-2023, 06:19 PM
Replies: 4
Views: 402
Posted By TedRamAirII
I did mention it, Cliff didn't say if it mattered...

I did mention it, Cliff didn't say if it mattered or not, and I don't think the kit is any different, he didnt say if I needed to replace any jets or rods? We really didnt discuss it in depth. The...
Forum: 67-69 Firebird TECH 04-09-2023, 07:37 PM
Replies: 12
Views: 826
Posted By TedRamAirII
No, Just one size, 11" .

No, Just one size, 11" .
Forum: Pontiac - Street 10-02-2022, 08:22 PM
Replies: 21
Views: 2,337
Posted By TedRamAirII
This works great, you can put the Engine and...

This works great, you can put the Engine and Trans in, one shot. its pricey, but if you do it more than once, it works. ...
Forum: The Body Shop TECH 06-25-2022, 10:11 PM
Replies: 15
Views: 1,756
Posted By TedRamAirII
SPI Barry is who to call, he runs the show at...

SPI Barry is who to call, he runs the show at SPI, and can answer/help with any issue you have.
Forum: Pontiac - Street 05-01-2022, 11:56 AM
Replies: 24
Views: 2,656
Posted By TedRamAirII
On the Alternator belt, just try to turn the...

On the Alternator belt, just try to turn the alternator pulley, if you can turn it, its not tight enough. I think pulleys get worn and Too Smooth. I bead blast them to give them a little surface to...
Forum: Pontiac - Street 01-19-2022, 11:20 PM
Replies: 1,977
Views: 261,870
Posted By TedRamAirII
Maybe come to Ocala. Check out Don Garlits...

Maybe come to Ocala. Check out Don Garlits Museum. Call NPD and see if the Car Collection is open to see.
Forum: Pontiac - Street 10-05-2021, 12:48 PM
Replies: 49
Views: 5,784
Posted By TedRamAirII
I would start at 4500 and make runs. shift at 200...

I would start at 4500 and make runs. shift at 200 rpm increments, and log the runs.
Forum: Pontiac - Street 09-11-2021, 04:32 PM
Replies: 14
Views: 2,471
Posted By TedRamAirII
A more honest reply would be "all the alignment...

A more honest reply would be "all the alignment guys are too stupid to use Specifications for alignment" Toe, Caster and Camber are the 3 basic alignment points. ALL cars use them. With the new...
Forum: Pontiac - Street 06-19-2021, 10:00 PM
Replies: 39
Views: 6,591
Posted By TedRamAirII
I wonder if you just need to run the snot out of...

I wonder if you just need to run the snot out of it for a few hundred miles, to break in the rings?
Forum: Pontiac - Street 01-10-2021, 09:57 PM
Replies: 13
Views: 1,409
Posted By TedRamAirII
To keep the brake fluid from draining the...

To keep the brake fluid from draining the reservoir, just push the brake pedal down slightly enough that the ports are covered in the MC. Be sure the brake lights are not on! or disconnect the...
Forum: Pontiac - Street 11-09-2020, 10:21 PM
Replies: 29
Views: 4,564
Posted By TedRamAirII
I would want a M-20 for first gear! its going to...

I would want a M-20 for first gear! its going to be soggy!
Forum: Pontiac - Street 04-20-2020, 10:17 PM
Replies: 11
Views: 2,282
Posted By TedRamAirII
Pull the Pitman arm off, pull the internal clip...

Pull the Pitman arm off, pull the internal clip out, crank the car up, turn the steering wheel to the the stop, the output shaft seals will be in the drain pan.
Forum: Pontiac - Street 04-19-2020, 08:59 PM
Replies: 20
Views: 6,281
Posted By TedRamAirII
Has anyone checked out Paul Sandoval's books?...

Has anyone checked out Paul Sandoval's books? https://www.amazon.com/BUILDING-PONTIAC-TORQUE-SANDOVAL-PERFORMANCE-ebook/dp/B07ZNLJMJD
Forum: Pontiac - Street 03-31-2020, 07:41 PM
Replies: 41
Views: 8,370
Posted By TedRamAirII
Check your battery voltage at rest and cranking....

Check your battery voltage at rest and cranking. If it goes below 10 V. its done.
Forum: Pontiac - Street 12-16-2019, 09:26 PM
Replies: 34
Views: 5,253
Posted By TedRamAirII
Not many things are better, than seeing the world...

Not many things are better, than seeing the world through a new windshield.
Forum: Pontiac - Street 11-10-2019, 10:10 PM
Replies: 43
Views: 7,100
Posted By TedRamAirII
No Clutches, No Posi Lube needed.

No Clutches, No Posi Lube needed.
Forum: Pontiac - Street 06-23-2018, 10:24 AM
Replies: 22
Views: 1,205
Posted By TedRamAirII
Re=Arcing brake shoes has not been done for a...

Re=Arcing brake shoes has not been done for a long time. The issue of grinding asbestos linings into dust was forbidden. One thing you can do is use a press to slightly flatten the arc of the shoe...
Forum: Heating & Cooling TECH 05-30-2017, 10:36 PM
Replies: 34
Views: 5,932
Posted By TedRamAirII
r12 is the best and its not hard to get. OEM last...

r12 is the best and its not hard to get. OEM last installed it in 1993-94? its still around, as r134 will be here for a long time. The new r1234yf is $700 for 10 lbs. For now the wrecked cars in body...
Forum: Pontiac - Street 02-18-2017, 08:14 PM
Replies: 2
Views: 327
Posted By TedRamAirII
http://www.hotrodhotline.com/md/html/drive_shaft_h...

http://www.hotrodhotline.com/md/html/drive_shaft_harmonics.php

https://www.youtube.com/watch?v=KZ-m9ov3wYM

https://www.youtube.com/watch?v=Idk3BVDVHq4
Forum: Pontiac - Street 12-30-2016, 05:07 PM
Replies: 16
Views: 724
Posted By TedRamAirII
https://www.drivelinesnw.com/part-trouble-shooting...

https://www.drivelinesnw.com/part-trouble-shooting/vibration-analysis/angle-analysis/measuring-and-correcting-angle-problems/

https://www.youtube.com/watch?v=Idk3BVDVHq4
Showing results 1 to 25 of 34
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 03:52 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017