PY Online Forums - Bringing the Pontiac Hobby Together

PY Online Forums - Bringing the Pontiac Hobby Together (https://forums.maxperformanceinc.com/forums/index.php)
-   67-79 Big Pontiac TECH (https://forums.maxperformanceinc.com/forums/forumdisplay.php?f=431)
-   -   70 Catalina in el Paso (https://forums.maxperformanceinc.com/forums/showthread.php?t=851524)

newmexguy 06-29-2021 12:05 PM

70 Catalina in el Paso
 
5 Attachment(s)
Just placed a few days ago at the west side pick a part. ‘70 Catalina sedan . Viewed yesterday it is still nearly complete. Even wing nut was on air cleaner. Very good front clip and bumpers, front and rear.
400 2V engine is complete. Brackets power steering etc. Power Drum car. Perhaps there is someone within a days drive who can benefit from this. Rain this week so the usual crowds and vultures are less in number.

will slow gto 06-29-2021 12:26 PM

That alternator is minty! Always liked those wheel covers on the driver’s side.

bird72 06-29-2021 04:13 PM

Good ole El Paso, my old stomping grounds when younger. I am going to be around SW NM a lot more, so EP will be in my range of travels. You remind me it is the land of clean sheet metal.....

mgarblik 06-29-2021 04:52 PM

Quote:

Originally Posted by newmexguy (Post 6261019)
Just placed a few days ago at the west side pick a part. ‘70 Catalina sedan . Viewed yesterday it is still nearly complete. Even wing nut was on air cleaner. Very good front clip and bumpers, front and rear.
400 2V engine is complete. Brackets power steering etc. Power Drum car. Perhaps there is someone within a days drive who can benefit from this. Rain this week so the usual crowds and vultures are less in number.

That car is loaded with good straight parts. Very unusual to see a car of that age in a pick and pull, at least around here. Both front and rear bumpers are very straight and great cores.

77 TRASHCAN 06-29-2021 05:07 PM

Quote:

Originally Posted by will slow gto (Post 6261022)
That alternator is minty! Always liked those wheel covers on the driver’s side.

The alternator condition tells of approximately when someone may have last worked on it. No corrosion showing. May not have been long ago when someone tried to get it going!!!

Greg Reid 06-30-2021 08:28 AM

That car looks like it could be a driver without too much trouble. Looks can be deceiving but just saying...

Sent from my moto g stylus (2021) using Tapatalk

newmexguy 06-30-2021 10:58 AM

2 Attachment(s)
It is fairly rare to see fifty year old cars in yards down here. They are almost always large bodied four doors. Or strange odd balls such as Renault or AMC. The pick a parts have burned through a lot of remaining old cars in the 10-12 years they’re been in operation here. Most cars in these yards are belly button 00’s fwd, suvs, and a lot of discarded trucks of all kinds.
The alternator was likely swapped out for a chain store reman unit. Yard said it “runs” with white marker on windshield. The interior is pretty bad, dried out, cracked, with gooey steering wheel from sun exposure.
Am not trying to sell anything from this, just posting it up. My days of buying inventory to try to sell are over. Too difficult. “Junkyard Dog” and “row 52” were almost complete busts. I do know a full time seller who maybe? would be willing to pull parts and ship, but cannot guarantee anything. Maybe someone within a days drive could benefit from this car. Dave S

OG68 06-30-2021 01:59 PM

I check the inventory list every week to see what they dropped down and went out today to check on a 68 El Camino / manual trans that was laid down a few days ago. Coastal rust bucket. Rear axle and interior already gone as was the power steering gear which is what I was looking to see. 327 was still in the car and what appeared to be an automatic. Clutch pedal was cut off. But I did get a drivers side fresh air vent for $7 so it wasn't total bust.

Had some really Golden Oldies in the yard.
49 Buick Super with a good body, bad interior and straight 8.
56 Ford Sedan that someone was converting to a Rat Rod
A pair of 62 Thunderbirds

newmexguy 07-08-2021 07:31 AM

yep southern california is where the "pick a part" concept took hold, from what Ive heard. Just wish they would have had the idea to attempt to sell some of the older cars, whole. Instead of dumping them in the "general population". Too much bother, I guess.

Ben M. 07-08-2021 10:41 AM

Quote:

Originally Posted by newmexguy (Post 6262938)
Just wish they would have had the idea to attempt to sell some of the older cars, whole.

Lotta rules on that one. Some states won't even consider a car in a salvage yard as something that can be brought back to life. Others don't care. Most yards in SoCal had a holding lot for selling their complete cars that had some intrinsic value at the time - in the early 2000s it was 2nd gen Trans Ams\Camaros and random '60s 2 door cars they would hold for often ridiculous prices - but everything eventually goes out into the yard.

padgett 07-08-2021 11:03 AM

It depends on the individual state. In Florida there are two kinds of salvage titles: salvage rebuildable which can be restored to roadworthy and salvage cetificate of destruction (COD) which can be used only for parts.

If you can take three different COD cars (different VINs) and assemble one, a deputy can certify the result and Florida will issue a new VIN that can be titled, registered , and insured.

Asssembled cars have little value but it can be done. A clean Florida title with no branding adds about $300 to the value of a car. Some people here (mostly who have been burned before) won't touch a car with an out-of-state title. It took me over a year to get a proper title for the Judge and I had all of the paperwork.

David Brown 07-09-2021 10:46 AM

Padgett, are you saying an out of state salvage or a running car title? When I bought my 74 Grand Am from Pennsylvania, I drove it to south Florida and transferred the title with no problems. Easy, peasy..

newmexguy 07-25-2021 08:47 AM

Was at the U Pull on Friday, had a few hours off. Someone had taken the hood hinges, the carb, and air cleaner, and removed the steel wheels although not much else had been taken.
Seems that they were after miscellaneous front end hardware. The front clip was loose, hanging loose. The front skirts were lying on the ground. Bottoms of front fenders were good, only a tiny hole at extreme bottom rear of heel. Inner braces are fine. The headlight bezels were on the ground!! so I did buy those, and the alternator.
Alternator # is 1102491 did a search but only thing that came up was a joint called "ram air ranch" selling one for $299! Guess it had a more favorable date code, this one is 6 B 4.

johnta1 07-25-2021 03:04 PM

Quote:

Guess it had a more favorable date code, this one is 6 B 4.

1976 alternator, 37 amp.
Possibly for Firebirds.


:)

newmexguy 07-26-2021 06:20 AM

3 Attachment(s)
Quote:

Originally Posted by newmexguy (Post 6267042)
Was at the U Pull on Friday, had a few hours off. Someone had taken the hood hinges, the carb, and air cleaner, and removed the steel wheels although not much else had been taken.
Seems that they were after miscellaneous front end hardware. The front clip was loose, hanging loose. The front skirts were lying on the ground. Bottoms of front fenders were good, only a tiny hole at extreme bottom rear of heel. Inner braces are fine. The headlight bezels were on the ground!! so I did buy those, and the alternator.
Alternator # is 1102491 did a search but only thing that came up was a joint called "ram air ranch" selling one for $299! Guess it had a more favorable date code, this one is 6 B 4.

. Pics

newmexguy 07-27-2021 07:56 AM

2 Attachment(s)
Quote:

Originally Posted by johnta1 (Post 6267134)
1976 alternator, 37 amp.
Possibly for Firebirds. :)

Is externally regulated. (Delcotron 10SI) A google search was inconclusive, but am going with Feb 4th, 1966. guessing general application.

johnta1 07-27-2021 01:07 PM

Possibly the front half with the ID numbers is mated to an earlier external half.

That ID # is for a 1975-77 37 amp alternator usually 6 cylinder application). The date code is for 1976.
(for the front half with the ID #'s)

When the rear half was made, don't know.

:confused:

newmexguy 07-27-2021 03:40 PM

Yep guess then the rebuilder put a 10 SI and a 12 SI half together. Thanks for the input.

johnta1 07-28-2021 09:15 AM

No, it would be a 10SI front mated to a 10DN back half.
All the main components are in the back half.
The ID is on the front half.

If it works, use it as an external regulated alternator.

:)

newmexguy 07-31-2021 08:07 PM

Quote:

Originally Posted by johnta1 (Post 6267573)
Possibly the front half with the ID numbers is mated to an earlier external half.

That ID # is for a 1975-77 37 amp alternator usually 6 cylinder application). The date code is for 1976.
(for the front half with the ID #'s

Have to wonder - what in the heck is the Ebay one from "ram air ranch" Another ebay guy was calling his a Chevy / GMC truck alternator.
Blowing smoke?

newmexguy 08-23-2021 09:27 AM

Catalina part out
 
4 Attachment(s)
All the front clip parts are loose, on ground. Easy pickings. The front doors are gutted, probably for someone’s impala sedan project.


All times are GMT -4. The time now is 02:34 PM.