2nd Gen Round Port Turbo Headers
 

Built by Ron Watt at Tribal Tubes in 2012. I had them ceramic coated black by a local coating company.

Fit very well with only minor dent to clear my steering column and one minor dent to clear the frame. They performed flawlessly. Never had issue with header gaskets failing running 20 lbs boost and a guestimated 40 lbs of exhaust back pressure. These have 1 ¾ primary tubes and 2 ¼ V-band collectors. The pictures on the motor were sent to me by Ron to show the headers in the test frame he used to build them.
$700 plus shipping from 78664.

Are they stainless? Do you have any closer pictures of the welds?

Thanks

Mild Steel. I replaced the V-band with interlocking v-band and my welds are not pretty but they were effective.

TTT

New Price. $600 plus shipping.

Bump

$550 plus shipping.

$400 plus shipping

What are the chances of these fitting a 1st Gen front stub? I’ll be building mine soon with Mustang Rack mounted ahead of the crossmember. I will be cutting most of the crossmember out and using 1-5/8” 4130 Tube and front plate.


Sent from my iPhone using Tapatalk

I do not know what the fit would be like. If you are modifying the subframe then you can make it fit the headers. My concern would be the front motor plate. You would probably need to allow the exhaust to go through the motor plate. A second gen frame has front steering and I had no clearance issues. I was going to change to a rack and had no concerns with the headers or exhaust interfering with the rack.

TTT $400

@Colin70TA, I got your PM. I tried to reply but get the message below.

"Colin70TA has exceeded their stored private messages quota and cannot accept further messages until they clear some space."

Are these still available?

I'm waiting on a reply from Colin70TA. If he passes then they will still be available.

These are still available. TTT

I’ll take them. PM sent

** Sale Pending **

**Sold** Thank you Fast 69 and thank you PY