There's still time to get some Tri-y's for your 2nd Gen Bird for X-mas. I have less than 10 sets of D-ports for auto trans left over. I'm trying to get them out of the header Co's place by the 4th. These sets can be sold on a short term payment plan. I can split the payment into 2-3 payments.

Ron

There's still time to get some Tri-y's for your 2nd Gen Bird for X-mas. I have less than 10 sets of D-ports for auto trans left over. I'm trying to get them out of the header Co's place by the 4th. These sets can be sold on a short term payment plan. I can split the payment into 2-3 payments.

Ron

hello, i spoke to you when i was in the persian gulf this summer about a pair. Is there anyway you have a pair of d-ports for manual tranny left. 21/2 oe 3 inch collector doesnt matter. And id so would you be able to split the payments?

carlo

Yes Carlo, I remember you. Are you back for good or are you going back to the gulf?
What I have available at this time is D-ports for autos. Since the header Co has sold to a larger Co that only accepts huge orders. So I will be taking orders for the 4-speed/auto versions in about a week. After I finalize the deal with the new header Co that will also add a few features to the patterns.

Ron

Hey Ron,
Yes Im back from the gulf, for good. Im trying to start buying all the parts for my firebird. Well I guess Ill just have to check back in about the manula headers in a little while. My car is a 3 speed manual, should the ones for the 4-speed work?

Carlo

Yes they will work with a 3-speed manual to

Ron

Having missed the past few months on this matter, what is the cost on these? Material? Can you email me some info? [email protected]

hey ron, what is the status of the set for the first gen a-bodies?

Hey Ron,
In the first post you had said somehting about being able to accept payments. If there is another run of f-body manual tri-y's will you still be able to do that or was that a one time deal for the auto headers to get them gone?

Carlo,
So far its just for the auto D-port's left in inventory. The header Co's I have been working with to replace the one that made the earlier runs have been much easier to work with so far. Not sure if it can happen later or not.
Because any time a change like this happens so early in the actual production. It can set things back a bit on working capital.

Ron