PY Online Forums - Bringing the Pontiac Hobby Together

PY Online Forums - Bringing the Pontiac Hobby Together (https://forums.maxperformanceinc.com/forums/index.php)
-   64-65 GTO Tempest & LeMans TECH (https://forums.maxperformanceinc.com/forums/forumdisplay.php?f=429)
-   -   freeze plug question (https://forums.maxperformanceinc.com/forums/showthread.php?t=387671)

sub4600 12-15-2004 09:37 PM
I have a '65 GTO clone with a Pontiac 400 engine and it had only water in it and the temp went below freezing a popped the front freeze plug on the drivers side....I can reach the area, how difficult is it to replace and any suggestions. Thanks

sub4600 12-15-2004 09:37 PM
I have a '65 GTO clone with a Pontiac 400 engine and it had only water in it and the temp went below freezing a popped the front freeze plug on the drivers side....I can reach the area, how difficult is it to replace and any suggestions. Thanks

engineer 12-16-2004 12:47 PM
not difficult if old one is out. Get new one, green locktite, and evenly hammer it in place.

Goatracer1 12-16-2004 04:13 PM
FYI: They arent freeze plugs they are core plugs. They are there to get the sand out of the block, heads, Etc. from the casting process. Dont depend on them to keep your block from cracking if it freezes.


All times are GMT -4. The time now is 07:49 AM.