PY Online Forums - Bringing the Pontiac Hobby Together

PY Online Forums - Bringing the Pontiac Hobby Together (https://forums.maxperformanceinc.com/forums/index.php)
-   The Body Shop TECH (https://forums.maxperformanceinc.com/forums/forumdisplay.php?f=417)
-   -   Quarter Window Adjustment? (https://forums.maxperformanceinc.com/forums/showthread.php?t=408039)

goatman64 12-11-2003 08:42 AM

My thanks to all who have helped me thus far...I'm getting close but yet another question.

Just installed new weatherstrip...the new roofrail stripping now does not allow enough clearance for the 1/4 window to roll up (too much contact at the lower rear of the window). This is definitly the only hanging point as I took the stripping loose and the window rolls up. Is there an adjustment for the window? Can't see any that is evident. Thanks again in advance.

goatman64 12-11-2003 08:42 AM

My thanks to all who have helped me thus far...I'm getting close but yet another question.

Just installed new weatherstrip...the new roofrail stripping now does not allow enough clearance for the 1/4 window to roll up (too much contact at the lower rear of the window). This is definitly the only hanging point as I took the stripping loose and the window rolls up. Is there an adjustment for the window? Can't see any that is evident. Thanks again in advance.

merlin 12-11-2003 05:28 PM

Goatman, Yes ther is. Remove the panel and on the window mechanics you will find four adjustments that will let you move the window up, down, foward, and backward.It will be a hold down nut on a slot, once yoy loosen the nut then you can slide the window track. It is much like the adjustment on your alternator.Hope I helped you. Merlin

goatman64 12-12-2003 09:38 AM

Merlin...thanks alot, nothing I've tried has worked thus far...I'll give it a look later today.

engineer 12-12-2003 11:57 AM

the body service manual shows all the adjustment points and discription about what to adjust to move the window where you want it.

goatman64 12-12-2003 11:21 PM

Thanks all...I had been looking inside the window housing for the adjustments. Mine still had some sort of hard putty covering all but one of the adjustment nuts that I had to pry off to access. Got it taken care of and put back togerther...thanks.


All times are GMT -4. The time now is 10:30 PM.