I need to make split exhaust tips like those on a 65 GTO except I need to use a 2.5 inch diameter inlet pipe. I would use 2.5 inch ss tips. My problem is how to go from a single pipe to dual pipes without using up 50lb of welding rods. Does anyone have a plan for the sheetmetal or any tips on how to do this? Or is there someone who sells this size?

Thanks,

Bob

There are 10 kinds of people, those who understand binary and those who don't.

I need to make split exhaust tips like those on a 65 GTO except I need to use a 2.5 inch diameter inlet pipe. I would use 2.5 inch ss tips. My problem is how to go from a single pipe to dual pipes without using up 50lb of welding rods. Does anyone have a plan for the sheetmetal or any tips on how to do this? Or is there someone who sells this size?

Thanks,

Bob

There are 10 kinds of people, those who understand binary and those who don't.

The sponsor (PY) has a splitter '65 style chromed for 2.5 " exhaust. It is not an exact, but looks good when installed. It is in the PY catalogue though, and not in the Pypes site. Check that out. I think around $110?

Tripower: The big bad car and three little [gas] pigs!

THANKS ERIC, MY HARD COPY CATALOG DID NOT LIST THE DIAMETER. THE ON LINE CATALOG DOES.

BOB.

There are 10 kinds of people, those who understand binary and those who don't.

That was a hot tip but PY is out of stock on the 2.5 inch size. Anyone else have them?

There are 10 kinds of people, those who understand binary and those who don't.