Need Picture
 

Can anyone provide me with a picture of the factory cut hole in floor pan for a 64 gto 4 speed with console ? Some one started this car and the origanal is long gone

Nothing...
 

in the GTO Restoration guide? I'll see what I can find. I'm sure someone here has the info. Ron

Buy the new reproduction sheetmetal shift porch & then place it on the floorpan, side it forwards & rearwards until it "seats" on the curve of the transmission hump. Being that it is offset on the top of the tunnel & also over, felt to the driver's side it will only nestle in tight to the floor, in one location. Mark the sheetmetal with a magic marker & remove the interior of the floor where to porch fits & you will have a prefect re-creation of the factory cut-out of the hole for a manual shift car.

Here's one shot of the hole beneath the porch on a 65. This was originally a 4 speed car. Sorry for the condition but...

Floor
 

Thank You

Here's some pictures of my 64. Sorry I cut off the end of the tape on the front to back pic, but it was on the seam of the pan. Hope it helps.

lets try that posting pics thing again..... please bear with me, I'm a little new to this stuff.....