1964 Bellhousing inspection "COVER" A-Body
 

I'm looking for a original 1964 Bellhousing inspection "COVER" for the A-Body car.

The 1964 full size and 1965 and later A-Body covers are not the same.

Thanks,

Brian

[email protected]

the
 

correct 64 gto bell housing doesnt have an inspection cover, its part number 3320...

Not sure I follow you.

Doesn'T have a cover?

But you listed a partial part number?

Could you expand on your answer a bit?


Thanks,

Brian

like this one?

info
 

the 64 gto bell housing was a single year usage part, there was no inspection cover on this design... the aluminum ran constant from one side to the other.

the part number of the bell housing ends in 3320...

there is one on ebay in the buy it now section if you want to see pictures....

i have one for sale too, but its packed away!

heres a link to pictures of the correct 64 bell

http://forums.maxperformanceinc.com/...7;2A%2A%2A3320

tks

sam

The 64 bellhousing does have 2 bolt holes (1/4") on the lower section where a cover or plate would bolt to it running parallel to the flywheel. The 64 bellhousing I have is missing that cover but it shouldn't be to hard to fabricate one.

If you need a bellhousing I have one available also.

Thanks Guys,


I have the correct 64 Bellhousing. I'm looking for an original cover.

The 1965 cover can be modified to fit the 64 Bellhousing by cutting off the lower horizontal portion of it and using only the vertical part to bolt to the front side of the bellhousing were the flywheel is exposed.


Thanks,

Brian

so
 

you are looking for the flywheel cover not the inspection plate?

i would think you could modify any of them to work pretty easily...

tks

sam

It took a while, but I was able to snag one on eBay. Seems like as soon as I found mine, there was one on there every week. They seem to go for $75-100.

Brian, see ebay 220327801420.

Bob, that one on ebay seems to be missing an ear. My original 64 has an ear that goes over the starter, but the ear has a large hole in it that the starter fits into.

Take a 65 up cover straighten out the bottom put it on your bell trace the shape of the bell cut to fit and tin knock the dimple in the bottom