Wiring Harness Wrapping Details ?
 

Can anyone link me to some info on the correct way to rewrap a wiring harness?

You need the proper tape , start at the bulkhead connector about 2" in , go to the connector then go away from it , this way you do not have a loose end , at the 1st. intersection of wires wrap the intersection , then pull the roll of tape up to the farthest end away, and start to wrap there back to the intersection . It will be 1 continuous piece of tape until the end . When at the end tie a knot , pretty simple .

Thanks Chrisp,

Figured it out by looking at the old harness wrap really closely. Did it last week with the proper non-sticky tape and it came out extremely good!

Charles

Where did you get the non sticky tape?