pypes SGF13 and EVT13 splitters on 79 trans am Help!!!
 

HI

I am rather new to this forum. Been a member for a couple of years but dont post much,
but I read alot and learned much from this site.
I am from Belgium Europe and i have a 1971 and a 1979 trans am.


I have put a 1971 HO motor in my 1979 this winter.
got me some Hooker supercompetittion headers CR coated.
now I orderd IN octobre 2010 a PYPES SGF13V exhaust system, Header flanges and EVT13 splitters. Due to the oversees freight shipping it took 12 weeks to get to me
and I started installing it today. But the design of the tail pipes seem to have changed???
The splitters cant be mounted because the angle seems different to the pics on their site???
anyone had the same problem.
cant find adapters for the 3" system.
I need help :)

On my 3" pypes system the hangers on the rear had to be removed (were upside down) for the spliters to fit correct

You have pm.

t/a , he is trying to use a system that is not designed to use splitters.

M&L , you have mail.

the sgf 13 and ev 13 is what I have on my t/a if therear hanger is removed and the right and left back tail pipes swaped sides the end of the pipes will be in position to accept the splitters

I am still not seeing that working but always am open........

Got pics of what you did?

I do have some on my computer at home i will look to see if I have any of that in particular

Any luck with the pics?

No I did not have a photo that show the section in question,have one of tipps in place ,the x pipe , and headers

For the 3" system, you basically need to cut a piece of pipe like a pie wedge and weld in place to change the angle of the tailpipe end. Then the tip can be welded on. It's extremely tight putting 3" splitters in between the quarter and the leaf springs but I've heard plenty of owners pulling it off.